Electronics Forum | Wed Dec 13 13:42:57 EST 2000 | Mike Ihm
The dielectic absorption characteristic of printed circuit board materials is usually not listed on the manufacturers spec. sheets. Can anyone point me in a direction to help determine which laminate materials might exhibit better dielectric absorpt
Electronics Forum | Wed Jul 19 20:30:38 EDT 2000 | Dave F
Lennart: I think most laminators offer a halide free laminate. Two are Isola and Mica-Micanite. Contact the IPC Halogen-Free Materials Task Group
Electronics Forum | Sun Mar 26 19:54:47 EST 2000 | Marc
when would one use a difunctional base laminate material as a possed to a tetrafunctional base material? What possible problems are associated with each?
Electronics Forum | Tue Aug 14 15:45:06 EDT 2001 | davef
BOARD BAKING SCHEDULE: Bake time depends on the board thickness and construction. For laminated FR4 PCB, we bake between 6 and 24 hours at 100�C. ROOT CAUSE OF THE PROBLEM: Heating moisture entrapped between the laminations of the board too quickl
Electronics Forum | Tue Jun 11 22:06:06 EDT 2002 | scottxiao
I encounter the problem, it is easy for pad(copper) to drop off from the PCB, which is Ni/Au finish. so my question is whether there is any specification about the force between pad and laminate material, and does the PCB corpoartion test this parame
Electronics Forum | Wed Jul 09 16:12:01 EDT 2003 | Matt Kehoe
Right-o Dave, Thats the 2 lifted pads turned upside down so actually you are looking at the bottom of the base copper where it used to be attached to the laminate. mk
Electronics Forum | Wed Dec 22 11:12:33 EST 2004 | Steve
Does anyone have an opinion about the pro's and con's of Getek vs Isola FR408 laminate? What laminate to most of you call out? Thanks in advance for your feedback. Steve
Electronics Forum | Thu Dec 07 20:55:08 EST 2006 | Cmiller
Implemented 6 months ago and have noticed no difference in frequency of farting. Sorry, could not resist. Have seen delamination problem with IS-410 laminate. What laminate is everyone else using?
Electronics Forum | Thu Feb 15 22:55:45 EST 2007 | davef
Questions are: * Is the blistering in the solder mask or the laminate? * If the blistering is in the solder mask, what do the blisters look like [eg, size, quantity, distribution, etc]? * If the blistering is in the laminate, what do the blisters loo
Electronics Forum | Wed Aug 27 13:08:30 EDT 2008 | vladig
Td - is the degradation temperature for a laminate (board), while Tg - is glass transition one. There is one more (even more important) - delta Tg. They characterize the quality of the laminate material. Regards, Vlad www.sentec.ca