Electronics Forum | Thu Sep 12 10:45:29 EDT 2002 | pbarton
We have used a laser cut stencil 0.15mm (0.006") thick with 0.3mm (0.012") square apertures radiused in the corners 0.06mm (0.0025") to aid paste release. This approach with the (type 3) paste we use has proven successful on thousands of devices plac
Electronics Forum | Tue May 06 21:35:27 EDT 2014 | davef
Indium recommendations: 0201's: * Stencil Opening = 11mil x 16mil rectangle * Foot Print = 12mil x 15mil rectangle * Stencil Thickness = 5mils * Spacing = 9mils Note: The most common stencil being utilized, is the laser cut electropolished, and in so
Electronics Forum | Sun Mar 07 13:10:15 EST 1999 | Sam Sangani
| Has anyone used the mechanical stencil foil tensioning system from certain company that eliminates using stencil frames and epoxy & mesh? Any comments on whether it's worth looking into? We go through product revisions like we go through clean so
Electronics Forum | Fri May 11 03:55:22 EDT 2007 | lupo
Hi everybody, Please could anyone shed any light on the subject: resistance laser cutting with flux- calibration of LEDs during electronic assembly phase. Should special equipments be used? What is exactly the process? Thanks and Regards,
Electronics Forum | Fri May 11 10:48:51 EDT 2007 | Rob
Hi Lupo, Are you talking about laser trimming the current limiting resistors in front of the LEDs, whilst dynamically measuring their output to get set light levels? If so then you need a laser trimmer & a very good photodiode/comparator feedback l
Electronics Forum | Mon Jul 12 11:11:25 EDT 2004 | Stefan
For laser marking you don�t require as powerful lasers then for cutting. A 20 Watt laser diode does already a good job. Because of the safety requirements the laser operates in an enclosure, which means more $$$ if you want to use the laser in line
Electronics Forum | Wed Aug 25 17:09:53 EDT 1999 | Earl Moon
| | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products. Co
Electronics Forum | Wed Aug 25 15:51:58 EDT 1999 | JohnW
| Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products. Cons
Electronics Forum | Fri Dec 17 15:26:48 EST 1999 | Victor Salazar
We use a homeplate design with 80% coverage on the tab, and 100% coverage on the leads 6mil stencil. All of our stencils are laser cut electropolished. We have had good success with this.
Electronics Forum | Thu Aug 26 04:35:54 EDT 1999 | Wolfgang Busko
| | | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products.