Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Thu Aug 07 13:13:51 EDT 2003 | mantis
Its been awjile since i was on a Cp643e but it sounds like there is a difference between the table board width and the fast loader width,when a board is to be transfered from the fast loader to the table the knuckles on the fast loader mechanism shou
Electronics Forum | Wed May 11 20:25:38 EDT 2022 | mikevb
Thanks. Yes, I replaced the ffx board with a new one and made sure everything is cleaned. I did check the flex cable connect as I removed all of that to test continuity between everything. It all checked out continuity wise. I also tried to disable t
Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Wed Oct 03 08:34:55 EDT 2018 | smp
Dear SMTnet forum users, I'm trying to debug a XY problem that i have on a sigmaprint 500 printer. The problem is that The XY table fails to initialize and SigmaPro complains with : SigmaPro received a invalid message from slave Y_INIT_ERROR I'm
Electronics Forum | Fri Jul 10 19:53:31 EDT 2015 | tamazula
make sure noting stock in the X ,and motor brake > work usually machine supply 24V to motor brake > wire for release brake then move until hit the > end stopper for init motor if brake keep on > that will the error message > > i got it ofte
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
Electronics Forum | Fri Jul 26 04:21:24 EDT 2013 | chris_flex
You`re right this is also a possible reason. But we have 2 Loaders from 1997 here where the error comes from the plc-program . Although all sensors are working fine the bottom conveyors are always running. We`ve planned to modify the program. BR
