Electronics Forum | Tue Sep 14 13:40:50 EDT 2004 | paul_boxboro
I feel your pain. Your company may already be using Kapton tape labels for their board serial numbers labels. Kapton is able to withstand repeated wash and heat cycles, and can be printed on a typical Zebra printer. The key to a successful and accura
Electronics Forum | Tue Dec 19 03:46:24 EST 2006 | en
I facing problem when running glue process. the glue size cannot maintain with the same size when the glue in syrince reduce. it become smaller, smaller and smaller compare to the time. Beside, when there have any changing model, the machine stop for
Electronics Forum | Fri Oct 29 18:24:46 EDT 1999 | B.Smith
JC, We 'had' this problem previously, but eliminated it for good by using the following: (1) Create a procedure for part orientation that follows IPC standards. Give a copy of this procedure to your receiving department, your buyers, as well as all
Electronics Forum | Wed Dec 09 15:54:05 EST 1998 | Dave F
| Hi, I know for sure that by controlling temp. and humidity | conditions in SMT assy lines room, one gets advantage in | screen printing, adhesive dispensing, and pick&place | machines mainteinance. Does any one have any advice on why | else is a c
Electronics Forum | Wed Nov 07 17:57:01 EST 2007 | jmelson
OH! He he, St. Louis! I have recently acquired a very good P&P machine, and am in the St. Louis area. I got the machine primarily for my own manufacturing, but there is plenty of time available on the machine. If you'd like to see how the process
Electronics Forum | Mon Nov 22 13:26:33 EST 2021 | dontfeedphils
I purchased, ran, programmed, and maintained a RPS slide for a number of years and can't say that I had any major complaints about it. It ran well as long as it was maintained well (which is no different than any other SS I've worked on). Support w
Electronics Forum | Mon Nov 22 07:00:57 EST 1999 | JAX
Sam, Cyber Optics inline paste measurement machine is probably the easiest to program, maintain, and operate but it does have some drawbacks in my opinion. It is slower than some other machines on the market. This might not be a problem unless
Electronics Forum | Thu Jan 14 10:25:36 EST 1999 | J. Coogan
Doug The 4796A and 4796R machines maintain maximum tact time within an XY table movement window of approximately 17mm. In addition, due to their ability to perform "on-the-fly" theta correction, they are also able to maintain top speed for a larger
Electronics Forum | Wed Jun 12 11:14:57 EDT 2002 | pjc
Sam, Like I said, AOI for pre-reflow inspections is the easiest to program and maintain. Each vendor of AOI has its pluses and minuses for programming and performance. Do a careful investigation of each vendor to learn about their machine performanc
Electronics Forum | Thu Sep 25 09:13:21 EDT 2003 | davef
Pete: That ACL Staticide� is used on the bulb of the Arach Technology & Application Corp Vacuum Pen� to attain ESD proprties, make us uneasy. "Staticide" is a topical anti-static solution. It's a soap that absorbs moisture from the air to improve