Electronics Forum | Mon Sep 27 08:52:11 EDT 1999 | Brian
| i had a problem here, during the wave soldering process, we apply a water soluble mask on the gold finger to protect it from contamination. But after washing, there is still some mask left on the gold finger. | Can anyone pls advise is there any pa
Electronics Forum | Wed Aug 11 13:34:58 EDT 1999 | Dave F
(snip) | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a little later on. It has
Electronics Forum | Wed Aug 11 09:51:11 EDT 1999 | Brian
| | | Easy goods-in polymerisation check: clean, white, cotton cloth: wrap it round a suitably gloved finger and pour a few drops of methylene chloride (! toxic) onto the end of the finger and rub it onto the bare board for a minute or so. If it come
Electronics Forum | Thu Aug 12 05:33:23 EDT 1999 | Brian
| | (snip) | | | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a little later on
Electronics Forum | Thu Aug 12 22:23:23 EDT 1999 | Dave F
| | | | (snip) | | | | | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a little
Electronics Forum | Fri Aug 13 10:39:25 EDT 1999 | Boca
| | | | | | (snip) | | | | | | | | You're quite right. However, anyone who uses MeCl in an aerosol spray needs his head examining. I'll go further: if he continues, he will most CERTAINLY need his head, the rest of his CNS and his liver examining a
Electronics Forum | Wed Oct 13 14:27:08 EDT 1999 | mikeh
Dave F, We are currently using a latex based ambient/thermal cure material that is applied by hand or automated dispensing equipment. Printing is an option for us, but we have not had much luck with this particular material. The mask is peeled off a
Electronics Forum | Sat Dec 19 16:54:43 EST 2009 | edmentzer
We use WSM-90 which is a red water wash off solder mask from Contronic Devices, Huntington Beach, CA, 714-897-2266. We bake the bare board at 150 F for 30 minutes after applying the mask. We run 130 to 140 F DI water in the inline cleaner which rem
Electronics Forum | Sat Jan 23 12:37:35 EST 1999 | parag palshikar
hi, i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier process ut
Electronics Forum | Thu Feb 14 23:37:38 EST 2008 | operator
That is bizarre. I would have to say that you need to do a test on the PCB to test solderability with an iron like mentioned before. If you don't find that the pads are contaminated or masked over lightly and the pads do take solder effortlessly, you