Electronics Forum | Thu Oct 04 17:45:10 EDT 2018 | avm
Hello friends, I'm looking for hints where to buy metal/steel sheets for stencil cut. Worldwide. Different quality, thicknesses and surface treatment.Size 23x23, 29x29. I heard there were some good quality metal sheets suppliers in Finland, Japan, M
Electronics Forum | Thu Oct 21 08:25:23 EDT 2004 | fcox
What are the most common solvents/processes being used to clean paste from metal stencils? Any heat?
Electronics Forum | Mon Nov 15 19:08:47 EST 2004 | grayman
For fine pitch components we would suggest slow movement of metal squeegee. The effect of angle is minimal. You may check squeegees from Transition Automation they can help you with the holder and the best squeegee. I do not have the web site, Arman
Electronics Forum | Thu Feb 12 20:36:26 EST 1998 | Jon Medernach
| Using metal squeegees on GSPs has caused premature stencil wear. Has | anyone had any success with this combination? How much snap off did you | use? We are using .5 mm pitch and have a no clean process. Stencil wear is is minimal but exists. T
Electronics Forum | Sun Nov 05 22:55:29 EST 2006 | KEN
Is it possible something is wrong with your solder paste?
Electronics Forum | Thu Oct 04 17:49:13 EDT 2018 | avm
Just uncut steel. No apertures.
Electronics Forum | Sat Oct 20 07:19:02 EDT 2018 | jingyiprecision
Hello Friend , How are you ? We are a China factory of metal parts , The process include cutting ,punching ,Machining and etc... ,Could you share more details of your product ? Do you have drawing ? Our engineer will check and advise . Maybe you ca
Electronics Forum | Fri Nov 05 17:29:53 EST 2004 | Steve Stach
Most metal stencils today are cleaned with a water based cleaning solution. 3 choices are most typical: (1) Water only for water-soluble paste (2) Water + Organic for rosin and no-clean (low residues. This affords lower temperatures and is easier t
Electronics Forum | Fri Oct 22 07:35:02 EDT 2004 | davef
Most glue suppliers recommend chemicals and methods for removing the product from stencils. What does yours suggest? Further, search the fine SMTnet Archives for background discussion.
Electronics Forum | Mon Nov 01 08:34:06 EST 2004 | fcox
What I am really after is what is recommended to clean the paste from the stencil. What works best? What is really used in common practice?