Electronics Forum | Thu May 19 05:25:54 EDT 2016 | buckcho
Hello, that's why some machines still use 2d for most of their algorithms and checks. They use the 3D on some special cases (like lifted leads). The full 3D machines are for me more complicated, because you can't use some simple 2d checks where appli
Electronics Forum | Fri Apr 20 14:11:27 EDT 2012 | rway
Programming is different, yes, but so is the terminology. ///with machine vision you have parameters that select what is good and what is bad, and you have parameters that help make bad look worse and good look better making the difference between w
Electronics Forum | Wed Nov 29 01:25:53 EST 2006 | callckq
Dear All, I have 1 product that using solder bar from vendor called Asahi. After wave process, we found quite a sticky flux residue remain on the board. Eventually, have huge impact on our ICT fisrt pass yield(FPY). Current FPY is a the range of
Electronics Forum | Wed Dec 20 18:26:28 EST 2006 | sjlevin@ix.netcom.com
We use a solvent called AK-225ATE (there is also AK-225T) that works great for removing RMA flux residue and no-clean flux residue. Info at http://www.AK-225.com
Electronics Forum | Wed Nov 29 11:56:10 EST 2006 | CK the Flip
For the better part of my career, I've battled with ICT guys on so-called "flux residues" on their test probes, and this was when using NO-CLEAN, 2% to 5% solids tops, flux. People don't understand that ICT probe maintenance is an inherent part of
Electronics Forum | Thu May 26 18:55:15 EDT 2005 | bakersm
I have been comparing Mirtec to Yestech on a regular basis. As a AOI trainer and installer, I have seen significant difference between the machines. 1. In a side by side comparison just today, using the same board, I found the following: a. Insp
Electronics Forum | Mon Apr 12 13:24:46 EDT 2021 | robl
I'd get Mirtec in first and see if you can bring over any elements of your current programs to their latest platfrom & if you could be doing anyhting better on what you have. Mirtec's are pretty tunable to reduce false calls, so it maybe that even i
Electronics Forum | Fri Jun 17 17:11:59 EDT 2005 | stansmt
I have been working with the Yestech system in my facility after evaluating the Mirtec. The yestech system has far less false calls and better defect coverage based on the test vehicles I ran. The YTV-1000 out performed the Mirtec in defect detection
Electronics Forum | Fri Dec 14 08:06:39 EST 2007 | gcamac
I have had an inline Mirtec for around two years now and we like it overall. The false calls we see are due to the lack of consistancy of the markings on the components. This usually causes some tweeking to the library when the first piece is produ
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
