Electronics Forum | Fri Aug 19 11:18:27 EDT 2005 | liujh
I am Jack Liu, I must clarify all of these in the business with Stefan, and let all of the dealers know which kind of person the Stefan is! For this used machine sales, we have invoice with Stefan and remark as follows(He had confirmed the invoice):
Electronics Forum | Fri Aug 19 11:19:49 EDT 2005 | liujh
I am Jack Liu, I must clarify all of these in the business with Stefan, and let all of the dealers know which kind of person the Stefan is! For this used machine sales, we have invoice with Stefan and remark as follows(He had confirmed the invoice):
Electronics Forum | Thu Sep 09 08:02:14 EDT 2021 | majdi4
Hello Evtimov , two parammeters must be controlled : 1) Frames tension must be controlled with tension meter ( attached photo ) 2)Also stencil thikness must be controlled with a Micro meter palmer
Electronics Forum | Tue May 02 18:08:32 EDT 2006 | Nirmal
are u using 3d / 2d camera 1) machine setup support pin must be strong. 2) machine part libary must be perfect and good condition. 3) using the right nozzle. 4) check the board clamp must be clamp fully. 5) and we can also try doit head and camera
Electronics Forum | Wed May 04 10:42:55 EDT 2005 | nice90
Handling a PCB 1. Check your ESD slippers and ESD Strap first before entering the SMT production line 2. A PCB manufactred over 90 days must be stored first on the baking Oven before Production 3. Temperature on the Baking oven must be 125plus and m
Electronics Forum | Tue Sep 02 22:21:26 EDT 2008 | davef
IPC-6012 Table 3-2. States "Fused tin-lead or solder coat - Coverage and Solderable". The lack of any specific dimension criteria doesn't make this any less a requirement. There must be complete coverage of solder on the land, and it must be wettable
Electronics Forum | Fri Feb 12 12:58:42 EST 2010 | smellew
CC is a must. IIS must be installed & setup on windows regards Llew
Electronics Forum | Wed Feb 29 10:00:48 EST 2012 | cyber_wolf
In order to clean the clutches properly, you must disassemble them. Did you do that ? The nozzle holder sensor dogs must be clean and scratch free.
Electronics Forum | Fri Dec 22 05:24:23 EST 2017 | protokos
Hi ii is possible to clone a hard disk, but the calibration data must be backup first. if this not can, then the machine must be calibrated.
Electronics Forum | Wed Jan 10 21:03:02 EST 2024 | madisreivik
Vision error found: YOU MUST CHANGE LAMPS SOMETIMES ! Also, the camera front-glass (with the cutout) must be correctly positioned :) Still looking the Q error on left head. Probably mechanical problem...