Electronics Forum | Fri Sep 05 09:42:41 EDT 2014 | cflames17
If you call service they can also walk you through the motor test. Ask for Glen. Al no longer works for MYDATA.
Electronics Forum | Mon Sep 08 09:04:41 EDT 2014 | chemers
Steve. It would be great if you could talk me through this independent motor test. Is there a good time to call? Thanks. Rebecca
Electronics Forum | Thu Sep 11 17:18:13 EDT 2014 | tech1
You may want to check the brushes in that motor, could very well be the "dust" that you have seen.
Electronics Forum | Tue Oct 27 11:20:16 EDT 2009 | smtspecialist
I had the same problem back in March with my MY12, since I have two identical lines i swapped things around until swapping the x-wagon motor (the one for fine movements). When I swapped the x-motor I move the problem from one line to the other gener
Electronics Forum | Thu Sep 04 16:36:29 EDT 2014 | chemers
Thanks for the response, Rob. I tried the MOT cards and the problem did not move. I swapped the MOTY with the MOTX, but the MOTX had a small board attached to it that I moved to the MOTY that I tried. Do you know if there is a way to test that small
Electronics Forum | Mon Dec 26 18:02:37 EST 2022 | rgduval
So, your Hydra Z message timed out... A couple of potential causes: 1. Hydra MOT card failure 2. Hydra z-motor failure 3. Hydra z-motor encoder failure 4. Hydra z-lock failure 5. Disconnected cable 6. X-wagon cable Start by booting into service mod
Electronics Forum | Thu Sep 04 09:40:14 EDT 2014 | rgduval
I'm surprised MyData is pushing the service call. They're usually pretty good at walking you through some troubleshooting steps before going straight to the service call. So, the failure sounds like an encoder failure; the encoders are attached to
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
Electronics Forum | Fri Sep 05 09:56:58 EDT 2014 | island2013
Both Steve and Rob are on the right track in troubleshooting the error. We've received a fair number of machines that have had similar issues. The motors are independent and both go back to the MOT card of which we have repaired. Let us know if we
Electronics Forum | Wed Nov 16 18:20:39 EST 2011 | dontfeedphils
According to the message guide it just says that it's a error telling you to initiate the Hydra Theta axis. I suppose the encoder for the hydra theta motor could be losing count and causing it to need to be re-initiated, or it could be something to
