Electronics Forum | Thu Aug 14 12:57:45 EDT 2014 | rgeary
Does anyone know what the following error indicates on a MyData My12 running 2.9.2. "F-MOT-MSETDYN C/156"?
Electronics Forum | Thu Aug 14 13:49:26 EDT 2014 | dyoungquist
Motor control MSETDYN -> Initiate axis C -> Centering jaws 156 -> Motor timeout Did not reach specified position Hardware problem Looks like you have something wrong with the movement of your centering jaws.
Electronics Forum | Thu Aug 14 15:07:43 EDT 2014 | rgeary
Yes, thank you. Found out that machine ran over two parts to tall and damaged the cover plate over the centering.
Electronics Forum | Sun Aug 07 09:18:07 EDT 2011 | jjcarver
amplifiere error states, Amplifier setup error, programming during startup failed.. Cannot get machine to initiate anyone have this problem?? machine is a MYDATA19e
Electronics Forum | Sat Jul 03 14:44:12 EDT 2021 | rgduval
Meh...it's a Linux command line....but commonly referred to as a dos prompt. When I started on MyDatas, no one really knew what Linux was....
Electronics Forum | Sat Jul 03 14:16:06 EDT 2021 | tomdegas
Thanks Rob. I didn't know I can run DOS on a Linux Operating system. Tom
Electronics Forum | Wed Jun 30 20:35:04 EDT 2021 | rgduval
I have no idea what the messages mean specifically...but, it sounds like linux level errors, rather than TPSYS errors. Start by getting to a dos prompt, and navigate to those directories cited and make sure things look ok (files are there, directo
Electronics Forum | Wed Aug 21 06:19:17 EDT 2019 | mxtimra
Mydata TP9-2U gives error code MOT1-38/186:MSETDYNX What is that code ? Machine give that code and wont make start up process. Appreciate if someone has knowledge that code, thanks.
Electronics Forum | Mon Nov 19 17:43:16 EST 2012 | jaimebc
Theta error came back again during our first production run. Swaped motcards as a final attempt to find an easy fix and nothing. I swapped heads with another MYDATA to positively isolate the problem. And the theta error followed the head.
Electronics Forum | Tue Dec 18 21:47:14 EST 2012 | jaimebc
So just to update and close this thread, it was the ZFIB board ( the one mounted on top of the theta motor) that was causing the theta motor to error out) Problem fixed. $ 30 dls or so from MYDATA. Hope this helps some one down the road.