Electronics Forum | Fri Feb 08 14:46:25 EST 2002 | dod
Unicam has an interface that will program the dispense machine from GPD and the ouput has been validated by GPD.
Electronics Forum | Thu Feb 28 13:59:54 EST 2002 | Jeff
CircuitCAM is a Partner with GPD and worked along with GPD to create the interface to support their dispensers.
Electronics Forum | Mon Jan 28 12:09:27 EST 2002 | billschreiber
Hello Carl, Smart Sonic has introduced the Assembly Module for off line programming of assembly equipment such as GPD. You can see it on the Smart Sonic website: http://www.smartsonic.com Click on the AOI/StencilScan and GlueScan link. If you hav
Electronics Forum | Mon Jan 15 16:32:46 EST 2001 | Darby
Adrian, I'll go again. The term "snap off" on it's own refers to the distance between the bottom of the stencil and the top of the pcb. Sometimes referred to as "print gap". As you prefaced your question with "squeegee snap off" I thought you were as
Electronics Forum | Wed Apr 04 08:28:27 EDT 2001 | Cal
ZAM_BRI- I don't know how effective this may be but some points to include in the buy-off procedure: Before submitting the PO for the stencil you may also want to do a CAD to Stencil comparison to verify correct apertures.There are SW packages and co
Electronics Forum | Wed Jul 20 16:02:05 EDT 2005 | Inds
guys, I am having a problem. During my rework (SRT) process, I am trying to reach a board temp of 150degC b4 the top heater comes down for the actual rework process. Due to which the flux (tacflux 20)is burning off and i am seeing lot of non wetting
Electronics Forum | Wed Feb 07 10:36:33 EST 2007 | mk
Wow JAX. Way off buddy, I promise!!!! This is real as have all my posts. As an officer of the SMTA Atlanta Chapter for the second term, I am familiar with the Forum Etiquette.. Thanks for defending our site's honor JAX. I don't like people who ab
Electronics Forum | Tue Feb 13 11:20:59 EST 2007 | cevans MPM printer specialist
Off contact is generaly less favourable than on contact printing. print height becomes a issue towards the edge or foil clamps. If you Had little or no issues with your previous board vendor re-check your specs you supplied to your current vendor. If
Electronics Forum | Wed Apr 04 09:05:50 EDT 2001 | davef
check the fine SMTnet Archives for a similar thread http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=320Message2429&
Electronics Forum | Fri Apr 06 08:38:20 EDT 2001 | CAL
ZAM- Also check out our Feb empfasis (www.empf.org). We just published an article on stencils. Hope that helps