Electronics Forum | Thu Feb 12 17:21:07 EST 1998 | Justin Medernach
| I would appreciate any information concerning the wash and bake of blank Printed Circuit Boards | before assembly. | + Is it necessary to wash and bake PCB�s before assembly? | + If any, what is the reason for wash and bake of PCB�s? | + If any, wh
Electronics Forum | Sat Mar 25 15:27:21 EST 2006 | Mike ZIG
Hi all, What is the best oil to lubricate the chain ? Mike
Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Wed Mar 02 04:32:07 EST 2005 | Hannu
Hi all We have an Omniflo 5 (-97 vintage) with pin chain conveyor. Lately the chain drive motor has started to emit some chirping noises, as if there were a bearing running dry or something. Is there some kind of maintenance schedule specified for t
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Wed Aug 09 11:45:25 EDT 2006 | SWAG
We have an OmniFlo 7, 2000 vintage reflow. We are having conveyor problems. I checked the encoder and speed control board and everything is good per tech. manual operations. We removed the chains a couple months ago and thoroughly soaked/cleaned t
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
