Electronics Forum | Wed Aug 19 13:52:11 EDT 2020 | goldendragon
Hello guys, Please help me how to parallel the width chain, it is bow out in the middle and keep dropped the board in oven, I can't find anything there that I can manually adjust the middle width to the same size with the entrance and exit. HELP!!! T
Electronics Forum | Thu Aug 20 14:46:26 EDT 2020 | goldendragon
Yes, it's autowidth oven. I thought about manually adjust both end to match with the with the middle. Thank you very much! Tim
Electronics Forum | Thu Apr 06 16:08:17 EDT 2023 | jdengler
Thanks for the effort. I have the maintenance and operations manuals in PDF so they are not missing. It looks like the only place it will show which SSR controls which heater will be in the schematic.
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Tue Jan 16 11:16:10 EST 2007 | jaimebc
There is another screen where you can select the sprocket size, since we have an Omniflo 7 as well, it may be worth looking into. Go to Set up/Configure/Option/Conveyor. There you will see Options for different Drive sprockets. Ours have 21/55 tooth
Electronics Forum | Wed Aug 01 11:22:25 EDT 2012 | davemac62
ERROR: "The specified i/o operation on DeviceHarddisk0Partition01 was not completed before the timeout period expired" This is followed by out of control conveyor speed and zone temps. Oven recovers when the error is acknowledged. This is happenin
Electronics Forum | Fri Nov 02 14:22:20 EDT 2012 | marcelll
Hi, I'm looking for a copy of the Omniflo oven firmware. I'm talking about the model running under Win NT. Oven vintage is 1999-2001. Our oven is a 7 zones but I thing there's only one firmware for all the Omniflo ( 7, 10 12 zones . The original was
Electronics Forum | Thu Aug 20 16:28:11 EDT 2020 | cyber_wolf
My guess is that someone either clamped a board or a ramp at the end while adjusting the width. I have had this issue before. Remove the rails and look down them like a gun sight. I have never had any luck trying to adjust out big bends. If you wan
Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Wed Aug 09 11:45:25 EDT 2006 | SWAG
We have an OmniFlo 7, 2000 vintage reflow. We are having conveyor problems. I checked the encoder and speed control board and everything is good per tech. manual operations. We removed the chains a couple months ago and thoroughly soaked/cleaned t