Electronics Forum | Thu Mar 29 20:15:41 EDT 2007 | darby
PCB > Origin > Origin 0 4 Teach the corner of the pcb at the mechanical stop. This data is from the machine origin. For a unit with a teach camera it will probably be around -25x, 95y. For a beam sensor around 70x, 28y. This is for a right to left
Electronics Forum | Thu Apr 21 10:34:06 EDT 2005 | patrickbruneel
Hi Y'all It would be valuable to the users of this forum to get a response from the original poster about his/her findings and solutions. It usually starts with the post of a problem, then opinions and experiences get exchanged but we never see a co
Electronics Forum | Wed Feb 08 22:22:34 EST 2006 | crashoveride
hello guys....... it seems to our team that your problem most likely originated to the board origin. seems to us that the two machines have diffrent settings. as what you've said, offsets on placements only happened when transmitting a program at bot
Electronics Forum | Mon Feb 26 08:39:09 EST 2001 | Cal
Previously posted, was information regarding "BLUE DOT" UV inspection. The link for original solutions was incorrect. This is a process where a UV signature is imbedded at the board level to visually check missing components, tombstoning and polarity
Electronics Forum | Tue Sep 01 11:46:09 EDT 2009 | andoe
when the cp6 loads a board everything seems normal / as the table drops the pcb lines up onto the origan hole and then instantly fails with -- "original pin error" we have run this board before. any ideas? thanks
Electronics Forum | Mon Jul 11 07:15:09 EDT 2022 | sophyluo1985
https://www.goldlandsmt.com/original-fuji-nozzle-vs-copy-fuji-nozzle/ If you have a better proposal, we can discuss it. please contact me, thanks
Electronics Forum | Tue Mar 19 09:17:16 EDT 2013 | rgduval
Any CSM84 geniuses out there? I've been working on these machines for about six months now, after spending 10 years on MyData's. I'm adjusting to the way the CSM's see the world, but, have run into something that I could use an assist with. I'm ha
Electronics Forum | Tue Sep 24 12:36:41 EDT 2002 | robf
But if the respondent could still click on the original poster's name he could contact him directly. If they are able to come to a conclusion between them that's great; if not, they could start a new thread and re-address the original or revised iss
Electronics Forum | Thu Apr 05 08:59:43 EDT 2007 | rgduval
Dave, I've seen some instances of solder as you mentioned "painted" over the joint. Almost looks like a seam between the added solder and the originally waved on solder. Typically, I've seen that in the past from an incomplete solder joint. One w
Electronics Forum | Mon Sep 15 17:38:57 EDT 2008 | bman
We've found that storage of other LEDs from this manufacturer can be very important. On page eight of the datesheet you attached, it says: "It is recommended that LEDs out of their original packaging are IR-reflowed within one week. For extended sto