Electronics Forum | Fri Dec 04 23:15:45 EST 2015 | mac5
You say that there is no green solder mask around the lands of the BGA only silk screen. If that is the case I would be concerned about the solderabilty of the component if the silk screen gets onto the pads. The application of solder mask is much mo
Electronics Forum | Fri Dec 20 10:13:38 EST 2002 | davef
The total inductance of a chip capacitor is determined both by its length to width ratio and by the mutual inductance coupling between its electrodes. So, a 1210 chip size has a lower inductance than a 1206 chip. Check with your supplier for recomm
Electronics Forum | Fri Dec 04 05:47:57 EST 2015 | rushpcbuk
In PCB design, a BGA (Ball Grid Array) package typically determines the number of layers that a Printed Circuit Board should have. However, the 4-layer board with a BGA package is commonly used than a 2-layer than an 8-layer PCB. On the other hand, t
Electronics Forum | Wed Nov 10 02:20:07 EST 1999 | Marc
The padsfor large heat sinks are being designed on our boards with large copper ground planes surrounding them by our engineers. I am having great difficulty keeping the reflow temperature below 230 degrees in order for the temperature of the copper
Electronics Forum | Fri Feb 13 11:46:23 EST 2004 | Jack
Is your customer trying to reduce voiding? If the device is using Sn90 / Pb10 and the paste is Sn63/Pb37 the board will melt first. However, if both solders are 183C eutectic, it's a tossup? PCB design, copper weight, bga type (pbga, micro bga, Tbg
Electronics Forum | Fri May 06 06:51:55 EDT 2016 | abhilash4788
Hi All, One of my customer has provided a pcb design having common pad for 0402 and 1206 package(i.e 3 pads in the gerber, pad1,pad2 belongs to 1206 package and pad2,pad3 belongs to 0402 package) Will this create any solderability issue. Is anyone e
Electronics Forum | Mon Apr 21 08:55:35 EDT 2003 | russ
The pads you use for Reflow will be be fine for handsolder. Russ
Electronics Forum | Mon Apr 21 21:46:04 EDT 2003 | davef
We agree with Russ.
Electronics Forum | Tue Apr 22 05:38:56 EDT 2003 | mk
This sounds like a job for ssd. No pad shapes to worry about. Look into http://www.sipad.net and please contact me off line to discuss it. Matt Kehoe mkehoe@sipad.net
Electronics Forum | Fri May 06 08:47:05 EDT 2016 | davef
You're correct. This design will have a record amount of 0402 rework for tombstoning and misalignments. Suggest that the pads on each end of all components be the same size in order to balance wetting forces during reflow.