Electronics Forum | Wed Dec 21 08:55:58 EST 2005 | russ
Most likely the temp controller itself if all of the above mentioned are fine.
Electronics Forum | Wed Feb 11 06:37:10 EST 2009 | reflowtechnologies
Please check the following: 1.Power supply. 2.SSR control power. 3.OTP or over temp protection at the software. Maybe you set it at low so it reads over temp even at lower temp. If still not ok you may check BTU service engineers. Brian Riggs
Electronics Forum | Sun Jan 06 19:43:48 EST 2008 | andrewlog
I think Panasert MSR is a good machine. You can easily program these machines using text files. Panasonic pubishes the format. The CM88 is harder to program. You will need to use the PT200 machine controller program. Different text formats can be imp
Electronics Forum | Wed Jan 21 09:33:41 EST 2009 | pigsinspace
Ok. As you know the machines changed a bit after 95 due to CE regulations. There are no drawing on board/box level in Panasert machines. However normaly i`ts the 100 volts thats "shorting out" the machine and shuts it down. Check all cooling fans a
Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
Electronics Forum | Fri Nov 19 15:17:36 EST 1999 | Vahid Vatannia
I just started my new job and I noticed that the humidity on production floor (electronics) is not being controlled. I have some basic understanding of why we need to control temp & humidity. Do you know if there is any benchmarking/studies done on t
Electronics Forum | Wed Dec 09 22:40:48 EST 1998 | phillip fhunter
| Hi, I know for sure that by controlling temp. and humidity | conditions in SMT assy lines room, one gets advantage in | screen printing, adhesive dispensing, and pick&place | machines mainteinance. Does any one have any advice on why | else is a c
Electronics Forum | Tue Mar 10 06:31:08 EDT 2009 | sachu_70
First evaluate yoru Reflow Oven: does it have independant temp control for Top and Bottom Heaters? This is a MUST.
Electronics Forum | Wed Dec 09 13:25:16 EST 1998 | Martin J. Ibarra
Hi, I know for sure that by controlling temp. and humidity conditions in SMT assy lines room, one gets advantage in screen printing, adhesive dispensing, and pick&place machines mainteinance. Does any one have any advice on why else is a clean room
Electronics Forum | Mon Jul 14 10:17:27 EDT 2008 | dwelch123
Ed,,You need a temp gauge to verify tip temp and if it's a digital control iron and it's off usually just junk it. If dial control you can loosen knob and adjust to reading.If you need to know type of gauge and manufacturer drop me a line