Electronics Forum | Wed Apr 19 14:46:08 EDT 2006 | cuculi54986@yahoo.com
We run Panasonic chipshooters, so our small nozzles are not cylindrical. We would use the smallest nozzle we have on our heads which I believe is a Panasonic "MF" size, the same nozzle we'd use for 0603 size components.
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.
Electronics Forum | Mon Feb 08 23:16:07 EST 2021 | mendez
Hi, so I was able to turn the machine on for a few seconds. It looks like the IC on the LCD doesn't have goo contact because it's very hard to keep the machine operational. I was able to see the table lifting for the first time; it was so cool! but t
Electronics Forum | Sat Mar 03 21:00:36 EST 2001 | edmond
Panasert machine is known for programming ease. Both machines having U-axis indexing unit which may crash due to operator mishandling. Comparing the reliability and accuracy, the MPAV is more stable to MPA3F. MPAV using full vision for part regconiti
Electronics Forum | Mon Nov 30 10:04:26 EST 1998 | Clint Hardee
Yes, the GEM series feeders are quite different. In fact, if you put CSM feeders on a GEM machine, you will probably break nozzles and crash the head due to the fact that the CSM feeders have a mechanical arm that sticks up toward the front of the bo
Electronics Forum | Sat Mar 11 07:33:52 EST 2023 | klauss
There's two kind of nozzles with different dimensions we use. One of them works good but the another one gives a head problem sometimes. The head picks the nozzle and gives the vacuum error despite the camera recognize it. So i make another head pi
Electronics Forum | Thu Jul 20 17:03:09 EDT 2000 | Darby
Ketan, If you are using a z-axis head, pay very careful attention to the pick up height so that you don't force the head into the component. Also pay very careful attention to the placement height, we set the component height to 0.05 to 0.1mm over th
Electronics Forum | Fri May 06 07:58:33 EDT 2016 | cyber_wolf
Darby, I'm not completely sure I understand. Juki machines have what is referred to as a multi-head. The offsets between the heads are the same as the spacing between 8mm feeders. So the (6) heads all come down at once and "gang pick" from 6 8mm fee
Electronics Forum | Fri May 01 14:39:43 EDT 2009 | jdengler
Swapping a servo amp out does not lead to an alignment issue unless the new amp is way out of adjustment. Did you do a "drift" adjustment after changing the amp? Does the axis vibrate badly while moving? More likely is someone crashed a head which
Electronics Forum | Thu Sep 23 18:56:42 EDT 2010 | slwolbert
Greetings all: I may have a simpler issue going on with this Fuji IP2 machine I'm struggling with. IP2 will boot and zero set, but if production is to be done, during the nozzle check sequence it gives a check nozzle message. This is due to the no
