Electronics Forum | Fri Feb 25 16:15:18 EST 2022 | mikesewell
see IPC-WP-019
Electronics Forum | Mon Feb 21 20:15:49 EST 2022 | arminski
since IPC-J-STD-001 RevH obsoleted the 1.56ug/cm2 UCL of ionic contamination tester in testing using ROSE test, how do you define the acceptable limit per PCB assembly? thanks
Electronics Forum | Tue Feb 22 02:51:25 EST 2022 | davef
The industry standard for Resistivity of Solvent Extract (ROSE) Testing analysis is IPC-TM-650 Method 2.3.25 – Detection and Measurement of Ionizable Surface Contaminants by Resistivity of Solvent Extract (ROSE).
Electronics Forum | Wed Apr 21 18:06:11 EDT 1999 | Cunli
| I would like to protect my SMTNet e-mail account from others who use my system. I can't seem to find the pass word feature. Although I do incurage going to the site on my system I don't like the idea that everyone can go through my e-mail. Jeff,
Electronics Forum | Wed Apr 21 19:42:12 EDT 1999 | Jeff Sanchez
| | I would like to protect my SMTNet e-mail account from others who use my system. I can't seem to find the pass word feature. Although I do incurage going to the site on my system I don't like the idea that everyone can go through my e-mail. | | J
Electronics Forum | Tue Apr 27 09:31:45 EDT 1999 | Robert L. McCallum
On circuit board assemblies first pass yields need to be above 98%, if a supplier is below this level it is a indication that: he has poor control of the manufacturing process; Poor component selection (price over quality; excepted a poor design from
Electronics Forum | Tue Apr 27 07:20:34 EDT 1999 | Richard Marks
I'm a mechanical engineer and we buy electronic pressure sensors and switches. In doing quality audits, I need to understand what "best practice" will yield in terms of conforming product first time through the manufacturing process? Any data out t
Electronics Forum | Fri Mar 28 01:45:10 EDT 2008 | En-Apple
I have problemabout fault reject rate at AOI very high, due to inspection letter or marking on IC body. It have uncleary. When I check at raw mat'l of IC it no problem but after pass reflow process it show marking not clear ( Laser marking type). Ple
Electronics Forum | Thu Jun 04 11:23:44 EDT 1998 | Frank S
If you could measure and chart 3 variables in my process, what would they be? The boards that I produce are on panels that are 12up and 2x4 up. All boards are single sided paper base w/o plated thru holes. They are on scored panels that measure 7"
Electronics Forum | Mon Mar 31 09:16:41 EDT 2008 | davef
What is changing the marking on the part? * Is flux residue coating the part to change the the way light reflects from the part surface? [Run a board with tape on the part, then remove the tape prior to AOI] * Is the heat of the oven changing the mar
