Electronics Forum | Tue Oct 09 14:59:52 EDT 2001 | slthomas
That's what we do with our MSHII's...setup one carriage offline while the other one runs. We also have setup carts to load the feeders ahead of time and haul them out to the lines. Of course, when we exceed the carriage capacity of 75 slots for an
Electronics Forum | Fri Nov 09 14:42:08 EST 2001 | vickt
Great advice!........Single tier feeder set-up carts are also available through Universal instruments directly for this exact purpose. Most people who really care about this changeover time have "pit-crews" that work in the component storage areas, o
Electronics Forum | Tue Feb 06 15:58:50 EST 2007 | Cmiller
You should still be able to buy one from Philips. I think they cost aroud $2,500 new. I think we may be willing to sell one. If your interested e-mail me at cmiller@adltech.com
Electronics Forum | Tue Mar 04 11:20:56 EST 2008 | wayne123
I am unfamiliar with the Philips Saphire. I am needing to know if the feeders That work on our Topaz and Emerald will also work on a Saphire. I assume that they would just because the feeders are being sold as "Gem" feeders. In addition, Is anyone a
Electronics Forum | Wed Feb 07 13:41:20 EST 2007 | coop
I contacted philips/assembleon and they said it was 1,200 new I think we might end up going this route, I've stacked up old trays before, would rather not restrict the amount of feeders I can load, but you're right it will get yah by in a pinch. than
Electronics Forum | Tue Feb 13 13:49:57 EST 2007 | coop
I am talking about an internal tray holder It holds two trays. the lingo doesn't really matter because if you say Internal tray feeder/holder the guys at philips will know exactly what you're talking about. I checked several refurb places and the onl
Electronics Forum | Sat Jan 22 05:08:15 EST 2011 | jeffr
For all Tray type components the machine will not pickup from the tray using the adjust assistant (f6). It will default to a position where you can place the QFP onto the nozzle yourself by hand.
Electronics Forum | Mon Jan 24 08:36:03 EST 2011 | davemac62
Thanks a bunch. I guess I did all the tray setup right. The adjust assist thing was kicking my butt!! On the right track now. Thanks again. Dave
Electronics Forum | Fri Jan 21 09:45:16 EST 2011 | davemac62
Thanks Jeff. Guess I didn't tell enough of the story. I can get the 1st part location taught (it looks like) but when I try to pick a part from the tray using adjust assistant (F6), the head changes to the appropriate nozzle and tries to pick from th
Electronics Forum | Wed Jan 19 11:44:47 EST 2011 | davemac62
I have a Topaz with 2 positions in the rear where component trays may be placed for limited tray component capability. There is not a lot in the manual on how to set this up. The Feeder Plate info is set up to allow Fix.tf. I have spec'd tray - fix.t
.gif)
