Electronics Forum: pin in paste (Page 2 of 104)

Press Fit Connector pin protrusion in Backplane

Electronics Forum | Thu Feb 08 00:40:37 EST 2007 | Scott

I think that as long as the compliant portion of the pin is completely in the board, pin protrusion should not make any difference. I have seen some large Aerospace companies internal specifications and the two requirements seem to be that the compli

Press Fit Connector pin protrusion in Backplane

Electronics Forum | Thu Feb 08 21:30:56 EST 2007 | Bill

Yes, many thanks for your reply.

Pin in paste connectors and lead-free questions

Electronics Forum | Thu Aug 22 23:09:34 EDT 2019 | sssamw

Yes, you need work with supplier to see if can run pin in paste for these connectors, even do some experiments. A step-up stencil would be good for these connectors, also connectors pin size and length match with PCB hole design.

Pin in paste connectors and lead-free questions

Electronics Forum | Mon Jul 22 09:53:13 EDT 2019 | kylehunter

Hey all! As background, I recently purchased a full SMT line for my company. We have a DEK 265, an assembleon opal xii, and a Heller 1500. Currently our jobs are leaded, and the heller is working perfectly. An upcoming job that we are potentially g

Pin in paste connectors and lead-free questions

Electronics Forum | Thu Aug 22 16:25:18 EDT 2019 | scotceltic

Yes, unfortunately a lot of datasheets these days do not contain the temperature resistance to determine if it can handle the PIP application. In the past I have always used a 250 C at a min of 5 sec for the material. Also, the part should have sta

paste in hole

Electronics Forum | Thu Jun 24 20:58:19 EDT 1999 | wayne sanita

hello, has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. thanks for the input wayne

Re: paste in hole

Electronics Forum | Thu Jun 24 22:58:21 EDT 1999 | Earl Moon

hello, has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. thanks for the input wayne Once you start, depending on applications, you'll toss your wave s

solder paste in Flipchip

Electronics Forum | Tue Feb 17 01:12:52 EST 1998 | J.H. Kim

In solder bumping in flipchip technology by splder printing, the precise control of solder volume and height is very difficult. Therefore I'd like to know the solution of this problem. Thanks

Problems with Maxim TQFN 38 pin part

Electronics Forum | Wed Mar 14 12:06:15 EDT 2007 | Oswaldo Rey

There is an approximate 1W dissipation and has a 2 sq in area below part on solder side as a heat sink, vias are to physically conect this solder side area to power pad, so its necessary to use an adequate amount of paste. I really don�t think it has

Air inclusion in solder paste

Electronics Forum | Mon Mar 27 20:53:12 EST 2006 | davef

If you believe: * There is air in your paste AND * You are not whipping the air into the paste ... You should: * Return the paste to your supplier * Get it replaced * Begin qualifying a replacement supplier. One thing before you go racing off to ly


pin in paste searches for Companies, Equipment, Machines, Suppliers & Information