Electronics Forum | Tue Apr 17 21:19:31 EDT 2001 | davef
Curious. Tell us more about: * Murata solderability protection * Solderability protection on the caps used to replace the Muratas * Reflow profile used with each of the two pastes * Differences in the two pastes
Electronics Forum | Mon May 13 14:15:46 EDT 2002 | davef
Entek is Enthone's OSP [organic solderability protection]. It is widely used in the PCB fabrication business. Imidazole (Via Systems) is good, but is not as widely available. Search the fine SMTnet Archive on: * OSP * Entek CU-56, Entek Plus CU-10
Electronics Forum | Tue Jun 04 15:21:20 EDT 2002 | jax
To make it simple: A Feeder protection plate is just a flat piece of metal that hangs over the feeders, inside the machine, and keeps the feeder cover from popping up and crashing the head.
Electronics Forum | Tue Jun 04 18:21:29 EDT 2002 | arzu
We have "conductive" coats,shoes,floors,chairs and wriststraps. I want to get rid of the wriststraps, for the wires can ruin a product during touchup and hand-building SMD components on paste. My Question: when do we have enough ESD protection?? are
Electronics Forum | Tue Aug 20 18:20:49 EDT 2002 | davef
Not more than 5 seconds. Iron tip temperature / solder alloy / flux composition / pad solderability protection / component termination solderability protection / cleanliness of the soldering iron tip / board design / ladeda
Electronics Forum | Tue Mar 18 01:18:15 EST 2003 | ereznahoum
Hi, I have to protect A small 3v battery power circuit with 2 layer PCB in plastic box against �Air ESD�. What is the best PCB layout for this purpose.
Electronics Forum | Mon Dec 29 03:56:04 EST 2003 | Tony Tan
We have do away with Kapton tape many years ago, now using the Titinium clip for GF protection during wave soldering.
Electronics Forum | Thu Feb 17 08:14:57 EST 2005 | davef
The issue may not be the solderability protection. It could be that the metalization on the component terminal or the metal of the component terminal was not prepared properly before the solderability protection was added.
Electronics Forum | Fri Apr 15 05:52:20 EDT 2005 | charly
hi Jon, does it mean the protective layer is coated after the immersion silver process? if we need to bake the PCb due to moisture issue, then we can not hold the pCB long due to the missing protective layer even with vacuum seal environment
Electronics Forum | Wed Jan 04 08:56:57 EST 2006 | james
In recent years we always seem to have problems with machines going down due to thunderstorms. I am trying to find a way to surge protect our Tyco equipment, anyone out there have any suggestions. It would be greatly appreciated.