Electronics Forum | Tue May 19 15:06:36 EDT 2009 | c111
we had many problems with this. there is no standard that I could ever find. we came up with our own after weeks of headaches. we use 25% as our guide line we use window pain only for the center paid to allow for out gassing and reduce 15-20% globaly
Electronics Forum | Sat May 30 01:31:49 EDT 2009 | mika
make 4 square rounded corner apertures on the ground pad and the total reduction of 20 % (80 % solder paste). Then you still be able to solder the terminals around. Don't worry to much of the void's. Just following my tips and you will be fine. The
Electronics Forum | Wed Jun 03 13:56:09 EDT 2009 | mika
less total area of voids, which mean a much more strength in the joint and much easier to solder such a cooling pad grounded via vias, with this approach! The same goes for big cooling pads of let say Power transistors without any via etc. Always re
Electronics Forum | Tue Feb 01 04:11:58 EST 2000 | emmanuel
I am to assembly a power SO on the top side of a double side board. My designer has implemented a lot of thermal vias in the heat sink pad of this component. The problem is that i need to prevent the solder cream from polluting the bottom side of the
Electronics Forum | Thu Oct 31 09:34:38 EST 2002 | russ
We do this all of the time, This is what we do but I would be interested in other methods. 1. Remove component with BGA type rework station 2. Wick off lead pads only, verify/create even solder surface on the thermal pad on the board 3. Apply no-cle
Electronics Forum | Thu Oct 31 01:52:17 EST 2002 | jason
Anybody with experience on such a rework ?? The QFP has thermal pads underneath the body and needs to be re-connected when subjected for rework... Any ideas ???
Electronics Forum | Wed Feb 02 03:32:08 EST 2000 | pascal MATHIEU
emmanuel : i agree with Dave , it's easy to have blind hole on the bottom side , of course in this case you'll lose some thermal efficiency ;the second solution is to put on the bottom side between the board and your heatsink a soft thermal interfac
Electronics Forum | Mon Dec 07 14:55:41 EST 2015 | clydestrum
So I have an issue coming up that I'm not too sure how to handle. A board was designed with the wrong footprint for a 3-lead transistor in which the single-lead side has a much larger (think thermal pad for qfn) copper land than what is meant for the
Electronics Forum | Mon Dec 16 10:31:21 EST 2002 | davef
Grant, On those 'dry pads', where does the solder paste end-up after soldering? On: * Pads * Component leads * Someplace else [Where?]
Electronics Forum | Mon Dec 16 21:51:28 EST 2002 | grantp
Hi, It's on the pads. They look ok, but when you check the lead comes away from the solder. Regards, Grant Blackmagic Design
