Electronics Forum | Thu Jul 31 03:20:29 EDT 2008 | miroyu
Hi everyone I have Quad 4C with following problem. When I run machine "cold start" first power up it will run and initialize but after if I turn it off and back on it will NOT initialize. Z axis will push nozzle down and it will remain i that posit
Electronics Forum | Mon Aug 04 04:58:23 EDT 2008 | stiva
Hi Sound like the same problem that i had. The machine after it had warmed up when initialising would drive the z rod down with the quadalign on checking for the nozzle height (I think). To me it seemed like an overheating problem as after allowin
Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Tue Sep 14 07:44:16 EDT 2021 | bukas
hi James. does this happen with every head or just Z6? Does the head move vertically at all? What ANC holder is selected in setup "Hole position detail"? There should be 4 options for "ANC hole position version". If the machine is CP45FV NEO then ANC
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Tue Sep 14 13:01:11 EDT 2021 | jamesatqkits
Hi Bukas, Every head, yes they move down, I should have mentioned the sensor is on the right , not the left. It detects the mirror swinging down. There is another sensor on the servo motor, its mirror home, it works I see it changing when I break the
Electronics Forum | Mon Sep 13 20:30:43 EDT 2021 | jamesatqkits
Hello all, thank you to the people that have been helping me out, Hristo and Bukas. I just thought I should put this out there and see if any one can help. When I try to pick up a nozzle I get the following error: [0800] <EMER&gt
