Electronics Forum | Mon Jul 08 15:20:12 EDT 2019 | daniel_marquette
Steve, all the worn carrier clips (chipped, spring less or damages, etc.)have been changed for working ones. Alignment has been performed to loser and afterward thighter tolerances than the manual recommend to see if it changes anything (no). I check
Electronics Forum | Fri Sep 10 14:25:07 EDT 2004 | Claude_Couture
We had the same problems a few years back. We complained and they came back with the excuse that the supplier of the parts had made a bad batch. They sent us a new part in exchange of the broken one. When faced with premature breakage of parts that a
Electronics Forum | Tue Jul 09 14:02:01 EDT 2019 | daniel_marquette
Unfortunately, I don't get the Jig but the component is always the same LED. I measured a sample of those and they are consistent from the tape and after the leads being cut. About 1-2% of the component from the tape are already bent so I'm still foc
Electronics Forum | Tue Jul 09 15:40:06 EDT 2019 | assuredtech
That's a great point about air consumption, don't reduce the 1/2 inch air line requirement, meet the CFM air requirement and of course dry shop air. Check the Auto oiler for the CTA is running correctly, 5W 30 NON Detergent oil only. Attached is a pi
Electronics Forum | Mon Jul 08 12:21:17 EDT 2019 | slthomas
I forget which type of CTA that machine has so I probably won't be much help. It's been ages since I worked on them but it doesn't look like you'll find many people that have. That said, usually if you get things aligned properly and it still bends
Electronics Forum | Mon Jul 08 16:03:06 EDT 2019 | slthomas
My recollection is that there is a carrier clip locator that positions (centers) the clip in front of the CTA. Has the adjustment on that been confirmed as well? (Edited because some of it's coming back to me!): I think there is a diamond shaped pin
Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Tue Jul 23 07:47:10 EDT 2002 | John S
We have a RAD5 and RAD 8, both of which have the Expanded Range Verifier. Has anyone had success verifying the correct value of electrolytic caps? Our machine stops several times a day for a false failure, and Universal isn't much help. Thanks John
Electronics Forum | Thu Jul 23 19:04:24 EDT 2020 | robl
The modular inserters usually have them built into the feeders, which is part of why each feeder is so expensive. I'm sure I saw one system with a separate clinch unit but they are all dog slow compared to a rad 5 or 8 or 6241D+.
Electronics Forum | Tue Feb 16 11:50:54 EST 2010 | remullis
I am currently placing LED's with a RAD 5 machine and developed cutting problems with a specific LED. I am not having problems with other similiar LED's where only the color is different. After dispensing to the clip all is well. After going through
