Electronics Forum | Thu Jul 03 11:27:06 EDT 2014 | bobpan
Try these things: 1. Reseat the cards (with power off) and Reboot the machine and see if the errors clear. 2. Unplug the nozzle changers and try to reboot....sometimes they can mess up the system. 3. If all the above fails.....the b-rams in the card
Electronics Forum | Wed Jul 30 03:03:12 EDT 2014 | torch
cheers turns out it was both, cards needed reseating and also the ram flushed :) its back up and running now :)
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Mon Apr 08 00:06:58 EDT 2013 | toddmahon
Have you had any luck? I just purchased the same machine and it has some kind of a boot error. After power up a screen pops up in Japanese with English sub titles. In the bottom left corner it reads Memory Card Data Error - Load Data. I connected to
Electronics Forum | Sun Nov 06 19:20:23 EST 2011 | jeffr
Tom, Does this only happen on one job or all jobs ? If this happens again..you should clear the RAM memory, but changing the 10 year 3v lithium battery on the motherboard should also be considered at the same time. RAM CLEAR PROCEDURE: Power off, rem
Electronics Forum | Tue Sep 14 16:45:20 EDT 1999 | Wendy Casker
Hey all, Just got a new PC whiz bang everything but the kitchen sink, and my Quad Gui software can't run on it. I keep getting insufficient memery errors. Any Windows gurus out there who can help? I can't figure out how to allocate the memory to m
Electronics Forum | Tue Sep 14 17:38:04 EDT 1999 | The Guc
| Hey all, | Just got a new PC whiz bang everything but the kitchen sink, and my Quad Gui software can't run on it. I keep getting insufficient memery errors. Any Windows gurus out there who can help? I can't figure out how to allocate the memory
Electronics Forum | Mon Nov 14 00:13:55 EST 2011 | tpappano
Hi Jeff, I pulled the proms from both machines, copied to disk, re-burned the the old versions with the newer and reinstalled. The ram became scrambled in the upgraded unit on startup, but I did a full restore through the serial port and unit #2 got
Electronics Forum | Tue Sep 14 18:32:59 EDT 1999 | DLKearns
| | Hey all, | | Just got a new PC whiz bang everything but the kitchen sink, and my Quad Gui software can't run on it. I keep getting insufficient memery errors. Any Windows gurus out there who can help? I can't figure out how to allocate the mem
Electronics Forum | Wed Sep 15 19:34:28 EDT 1999 | Earl Moon
| | | Hey all, | | | Just got a new PC whiz bang everything but the kitchen sink, and my Quad Gui software can't run on it. I keep getting insufficient memery errors. Any Windows gurus out there who can help? I can't figure out how to allocate the
