Electronics Forum | Thu Sep 16 08:47:39 EDT 2010 | headlad
I extended the pads to help ensure the component locates correctly and to allow for easier re-work should problems occur. I reduced the thermal by 5% but you may want to speak to your fabricator and ask what they require to ensure that the resist is
Electronics Forum | Tue Jun 22 12:22:34 EDT 1999 | David Spilker
| We have a need to add a trace to a large quantity of bare PB's. The trace goes from a 25 mil QFP pad to a via. The rework must be done before we process the board. The rework cannot interfere with the solder paste screening process. | | Does a
Electronics Forum | Wed Nov 17 09:02:57 EST 1999 | Dave F
John: The 180 Tg point is a sweet spot for obtaining heat resistance, cost effectivly. These high technology boards provide good thermal resistance for wire bonding, direct chip attach, and BGA mounting and rework. Since these boards are harder th
Electronics Forum | Thu May 20 07:53:55 EDT 1999 | Chris Nuttall
| | We care currently running into problems during our plug via process: | | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.Thi
Electronics Forum | Tue Aug 10 13:05:57 EDT 1999 | ScottM
| Folk's, | | I'm looking for some helpful suggestions for reworking wave soldered bottomside components that have been glued. | I'm not a fan of the twist and break approach and as some of them either have a double dot or a slot configuration this
Electronics Forum | Fri Feb 21 12:19:13 EST 2020 | richardcargill
People in general are fairly resistant to change ( I've found ) - however, we're looking at the same move to LCD cameras shortly. My main apprehension is the lack of stereo vision ( and associated depth perception ) when reworking under it but I'm s
Electronics Forum | Tue Aug 10 11:12:27 EDT 1999 | Steve_S
| Folk's, | | I'm looking for some helpful suggestions for reworking wave soldered bottomside components that have been glued. | I'm not a fan of the twist and break approach and as some of them either have a double dot or a slot configuration this
Electronics Forum | Mon Aug 30 08:38:46 EDT 2010 | rgduval
We appreciate your desire to find the most time effective method of reworking these boards. However, we believe that your most efficient method will be to have one assembler remove all of the parts, and a second assembler place/hand solder the parts
Electronics Forum | Thu May 17 07:36:40 EDT 2001 | Bob Willis
Here is a copy of a draft document on PIHR Inspection I have jotted down on a flight to Scotland yesterday, any comments suggestions etc ? I have already most of the photos for the standard but as you know there is nothing in the IPC document it just
Electronics Forum | Mon May 06 12:44:50 EDT 2002 | Bob Willis
The SMART Group is starting a new project on PPM Monitoring which will be providing average PPM yield data per month free to the industry. I would like to get feedback or exchange criteria for paste printing as non exists with in IPC or similar organ
