Electronics Forum | Fri Jun 12 08:37:21 EDT 2015 | cgreiner
Check to insure that cut outs in the PCB is not triggering the board sensor on the input of the unit. We had a few boards where the cutout in the board was seen as the end of the board and it would stop several inches from the board stop. We ended
Electronics Forum | Fri Jun 26 00:33:08 EDT 2020 | victorzubashev
Hello everyone, Can you please recommend a sensor to measure (contactless) level of solder inside of the wave soldering bath? ideally it should be a sensor that can reliably measure distanceto the melted solder and provide distance (as a codified si
Electronics Forum | Tue Apr 16 13:59:33 EDT 2002 | paulausten
They work great as long as your conveyor speed > has been calibrated and checked on some type of > PM schedule. On some oven types these sensors can > warn you to possible problems with the conveyor > speed. Say the oven is calculating that the b
Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag
Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma
Electronics Forum | Tue Mar 10 11:39:10 EDT 2009 | bobpan
Craig, Try this.... Go into 'machine-calibration-transport' then click on 'touch stop'. Reteach your board touch stop x for both gantries (if you moved both touch stops). If the board still does not reach the touch stop.....teach 'Board Positioning S
Electronics Forum | Mon Aug 06 14:05:02 EDT 2007 | slthomas
BEC hardware would be on the machine as a sensor underneath the placement table, to the left of the C&C, and an emitter attached to a bracket to the left of the insert head. The two line up with each other and the sensor uses a quadrant layout to det
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
