Electronics Forum | Tue Oct 11 14:58:52 EDT 2005 | vikkaraja
You do not need to buy any special cable for this purpose. Fuji normally has 2 pins connector attached at the end of each equipment. Now if you do not have those connectors, you can just buy some 2 to 4 conductor cable from your local electronic supp
Electronics Forum | Mon Jul 20 23:06:49 EDT 2009 | mika
10 or even up from a UIC conveyor of the old model - probably SMPI is the connector from UIC fully loaded, then full SMPI, but not all of them are used. Just Good board, bad Board, send, receive acknowledge. It is possible to convert this into SMEMA.
Electronics Forum | Tue Mar 17 19:46:41 EDT 2009 | dman97
Hi Mika, Why not just splice into the existing 2 pin connector on the beginning or end of the CP conveyors? See attached picture...
Electronics Forum | Mon Jul 29 10:21:38 EDT 2019 | aharper
Yes, they look like parallel port connectors. I traced the lines and I believe you are right about the SMEMA. Thanks for your input
Electronics Forum | Tue Nov 03 17:28:10 EST 1998 | smd
SMTnetters: My UIC conveyors aren't working with my: Omniflow 7 Reflow (Mfg 1/95) Dek 265 GS Philips CSM What can I do? Does anyone have experience with connecting UIC or other conveyors to the above equipment? On the reflow I jumped terminals 1
Electronics Forum | Wed Sep 18 16:56:55 EDT 2002 | stockley
I started writing a long winded explanation about SMEMA and realised that it is just as easy to write about this as it is to talk about it on the phone. It just so happens that I have recently gone through this process so I believe that your vendor
Electronics Forum | Wed Nov 04 18:13:53 EST 1998 | Michael Allen
I assume that you're dealing w/ Universal's SMPI connectors (and possibly their cables too). We've fabricated "conversion boxes" to accomplish what you're trying to do. These boxes have a female SMPI plug on one side, a female SMEMA plug on the opp
Electronics Forum | Thu Nov 05 09:10:23 EST 1998 | smd
MA: my internet e-mail isn't working at the moment, but I'd really love to see the conversion you created. My fax is 716-256-0792. Do you have a Dek printer or Omniflow oven? Many thanks to you. | I assume that you're dealing w/ Universal's SMPI co
Electronics Forum | Mon Jan 28 16:05:27 EST 2013 | jdengler
It's been a long time since I did this. I think if you get a cable (maybe from some of the used equipment dealers that advertise here) you will still need to change the contacts of the relay the Fuji uses. I think they use a normally closed set of
Electronics Forum | Thu Sep 01 11:17:52 EDT 2005 | chunks
There are many rules, but balance is the key. It all depends on your processes, type of equipment you plan to run the panel through, as well as the type of components going onto the board. If your single up circuit has 6 thru-hole caps, 5 connector