Electronics Forum | Fri Nov 03 02:32:56 EST 2006 | shivam
HI ALL, can anybody clear me what is via tenting and via pluging?? second one, if i use via in pad for an.5mm bga what care i should taken, what should be the soldermask open in top and innerlayers for via?how it will directly connect to top layer
Electronics Forum | Wed Aug 21 17:44:32 EDT 2002 | davef
Splitting hairs, I expect SIR of all solderability protection, including OSP, to decrease after reflow. What�s more, I expect the SIR of all solderability protection to pretty much decrease over time. The �comb pattern� test specimens meet requirem
Electronics Forum | Tue May 26 14:39:40 EDT 2009 | boloxis
QFN or MLFs are mainstream now, QFNs already evloved to much more complex versions now like matrix pins, stacked dice and flipchip versions. IPC 610D already includes them, just make sure the pins have solder plating, the PWB pads have soldermask in
Electronics Forum | Fri Mar 11 18:47:54 EST 2005 | davef
JD: It's important to note that FR-4 does not contain PBB or PBDE. The bromine in FR-4 epoxy comes in the form of tetra-bromo-bisphenol A [TBBA], which polymerizes and become part of the cross-linked epoxy. Bromine, in the form of hydrogen bromide, i
Electronics Forum | Thu Dec 28 14:50:56 EST 2017 | stephendo
Leather is not very insulative. AFAIK a lot of good quality dress shoes are naturally ESD safe. (or maybe test too low.) Check the dress shoes with a tester. And I'm guessing that stapling the straps is out of the question.
Electronics Forum | Tue Mar 14 07:59:41 EST 2000 | JAX
Emmanuel, The discussion on what finish to use whether it be HASL, Immersion gold over nickel, Organic Solderability Preservatives, ect...... is still ongoing. This is not the only decision you need to make. Do you plan on Soldermask Defined Pads? Wh
Electronics Forum | Tue Mar 14 07:59:41 EST 2000 | JAX
Emmanuel, The discussion on what finish to use whether it be HASL, Immersion gold over nickel, Organic Solderability Preservatives, ect...... is still ongoing. This is not the only decision you need to make. Do you plan on Soldermask Defined Pads? Wh
Electronics Forum | Mon Apr 12 19:28:26 EDT 1999 | Tom B
Netters, When I reflow a PCB there is a discoloration of silkscreen and mask. It appears if Profile is too hot! But I dont think so, maybe I'm wrong? 1. Kester 293 no clean 2. 2.1 C/s for 30s to 150 C 3. .5 - .7 C/s for 60s to 185 C 4. 1.5 C/s u
Electronics Forum | Tue Jan 08 09:23:18 EST 2013 | lock_2002
This is a question regarding soldermask between pins of fine pitch devices. The majority of our production designs end up with at least 2-3 mils of copper thickness on the external layers due to blind vias, wrap plating requirements, etc. Our curre
Electronics Forum | Tue Aug 02 12:05:37 EDT 2016 | ttheis
Leave a circular area around the fiducial without any mask so bare board is shown.