Electronics Forum | Mon Nov 27 17:47:23 EST 2000 | Dave F
Gyver: Lemme take a wack [if you�ll excuse the expression, given direction of the later discussion] at your questions. Q1. Will the baking of BGA or PCB cause more oxidation before the SMT process? A1. It certainly will not cause less oxidation,
Electronics Forum | Tue Oct 23 14:24:04 EDT 2007 | ratsalad
Who is your stencil vendor? I've used three different vendors for Pb-free green frame stencils and NONE of them charged extra.
Electronics Forum | Wed Oct 10 14:21:04 EDT 2007 | petep
We have done the Green Framed Stencils for an added $50.00 per, then got smart and went to green polyester on RoHS / Lead Free Stencils at no added cost. Dedicated Stencil blades and holders green of course) as well as Green Static mats on dedicated
Electronics Forum | Thu Oct 12 22:16:59 EDT 2000 | Dreamsniper
Hi Guys, I'd like to share this to all of you...you can start playing with the rests...Stated prices, if not indicated, are in Aussie $ or Singapore $. Stencil Printing Adhesive Pros a) Less Capital Equipment Cost (Short Term). In reality it is f
Electronics Forum | Thu Mar 25 19:07:22 EDT 2021 | llawrence
That is all a lot to take in, but thank you all for the recommendations. From what I understand, I'm going to start by ordering a new polished 0.1mm stencil with size reduced apertures and seeing if reduced paste deposit will help. As for the sten
Electronics Forum | Thu Mar 25 09:38:36 EDT 2021 | spoiltforchoice
Well everything Graham said with some additional points.. You mention manual printing but very little about your stencil or setup. Everything you have said indicates a very limited budget has been expended, however what you have is an extreme exampl
Electronics Forum | Tue Aug 01 19:52:19 EDT 2006 | darby
If your frame size is 730mm x 730mm then you can't move it left or right. If it smaller than that then the frame adapter will give you more leeway. I am not too sure by what you mean by "If I had a 6" board, and a stencil with cut-outs for both side