Electronics Forum | Fri Apr 02 05:06:49 EDT 2010 | atchoum
Hi, I'm looking for an adhesive which can be stencil printed, in order to assembled PET (top layer) with Glass (bottom layer) for resistive touch panel application. The adhesive should be deposited at the border of bottom &/or top layer. Do you know
Electronics Forum | Thu Jun 20 22:37:16 EDT 2002 | davef
You're correct. It's a GREAT deal, especially when you match it up against those rip-off machines that cost $25k++. Maybe products like this will get those very nice suppliers' attention and force them to price products reasonably.
Electronics Forum | Wed Nov 09 05:18:15 EST 2005 | pavel_murtishev
Good day, So, only material supplier recommendation is the basis for solvent selection. Am I right? BR, Pavel
Electronics Forum | Tue Jul 02 16:04:08 EDT 2002 | russ
We normally disregard what the "tech" sheets say. A lot of it has to do with your printer settings, prints per hour, placement time, stencil cleaning procedures etc... Just another wrench to throw in, We have noticed lot to lot paste differences al
Electronics Forum | Tue Apr 20 20:33:38 EDT 2004 | davef
You're correct, alcohol can cure or cause reactions in epoxies. While you're waiting for others to reply: * Read your glue supplier's application notes. They often discuss cleaning procedures and materials. * Consider searching the fine SMTnet Arch
Electronics Forum | Wed Nov 09 07:16:44 EST 2005 | pjc
Besides IPA, here is a list of links to cleaning agent suppliers besides Zestron, Vigon is a very good cleaning agent: http://www.envirosense.com/ http://www.kyzen.com/ http://www.petroferm.com/ If you give them your material mfr. and part numbe
Electronics Forum | Wed Mar 27 16:54:47 EST 2002 | davef
STARTING RANGES * Pressure � 1 pound/inch of blade (metal); 1.6-3 pound/inch (plastic) * Speed - 0.5 to 3 inch per sec [for standard pitch]; 0.5 to 1 inch per sec [for fine pitch] Your paste supplier�s recommendation is a good place to start. * Sepa
Electronics Forum | Thu Mar 29 11:36:49 EST 2001 | Rob Fischer
Our company and most others do no specify any specific chemistry but offer equipment with configurations for running the best chemistry based on your application. Listed in one of Mike Konrad's postings are the contacts for chemistry. Ease of maint
Electronics Forum | Thu Sep 12 11:26:11 EDT 2002 | scottefiske
CK, If joints have been validated prior to ICT (under BGA Scope), more often than not repeatable joint fractures are due to undo stress being placed on the component during ICT test. Verify ICT probes and fixture. If after proving out fixture/pin com
Electronics Forum | Thu Dec 06 08:57:32 EST 2007 | davef
With this small amount of background information on the situation, comments are: * If you let adhesive cure on your stencil, you should not be using Zestron 301. A hammer and chisel is more effective. * Assuming you are not letting the adhesive cure,
