Electronics Forum | Tue Feb 23 08:45:29 EST 2016 | proceng1
On my sequesncer, the Halt/Run switch is under a cover on the BACK of the machine.
Electronics Forum | Sun Nov 04 11:53:19 EST 2007 | osomemac
I am looking for a mini acceleration switch for my application. It will be high volume, 1-5 million in quantity or better when in final production. It have to be really TINY and light weight. Packaging is not as critical since we do epoxy coated t
Electronics Forum | Sun Nov 04 11:55:15 EST 2007 | osomemac
I am looking for a mini acceleration switch for my application. It will be high volume, 1-5 million in quantity or better when in final production. It have to be really TINY and light weight. Packaging is not as critical since we do epoxy coated t
Electronics Forum | Fri Feb 12 21:30:44 EST 2016 | athrunamuro
I have a VCD Sequencer, and to load an executive file, I have to flip the Halt/Run switch to get the @ sign on the monitor. Can anybody tell me what part of the machine the Halt/Run switch is in? I know where on the machine it is, behind the metal co
Electronics Forum | Mon Aug 08 19:26:22 EDT 2005 | Tom B
That uis correct if your wanting solderable gold it should be 10-17uinches, but for coantact suchas as switches and card edge 30 is used
Electronics Forum | Mon Aug 08 10:27:15 EDT 2005 | russ
I am a contract Mfgr. and we receive these designs quite frequently. ENIG is the finish and the designs do utilize pushbutton switches from membranes. I am not provvy to any reliability or performance data but we process alot of these designs. If
Electronics Forum | Fri Aug 16 03:13:32 EDT 2013 | rollon65
Hi Marcelo. I have used 2 non EU model 4C machines since 2002 that do this almost every time from a cold switch on. My local Tyco tech guy said that they all do it. They are still going after 12 years. I have another EU machine that does the sam
Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance
When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and
Electronics Forum | Mon Aug 19 15:21:17 EDT 2013 | marcelorotofrance
Hi Rollon, thanks for your answer. At this point it seems that cold-start current surge, because the presence of large value capacitors in the power source, exceeds the sensitivity of the protection switches rather than a malfunction. Nevertheless, i
Electronics Forum | Sun Aug 07 19:43:55 EDT 2005 | Tom B
I usually Spec out 20- 30 uinches of gold over Nickel (50-80 uinches). If the most conduction is needed use Immersion Silver, about 12-20 uinches). Tom
