Electronics Forum | Fri Mar 30 07:26:43 EST 2001 | pteerink
Sorry, that should have been addressed to Peterson Phil
Electronics Forum | Thu Nov 17 14:47:27 EST 2011 | davef
What is it that you aim to remove from your product?
Electronics Forum | Fri Feb 09 20:41:02 EST 2001 | CAL
We like our AOI from Cyber Optics but only use it for process prove out. I would rather have a solder paste inspection system in line. The cost of AOI is killer. A new process is to embed a UV signature between the components pads and when a componen
Electronics Forum | Thu Mar 29 20:39:37 EST 2001 | peterson
AOI systems are a LONG way from being practical. You might impress potential customers (if you are a contract manufacturer) But they are basically an over-priced gimmick. Get your processes in line, buy a good 3D paste height checker, verify componen
Electronics Forum | Wed Nov 16 18:02:08 EST 2011 | jaredbroach
I am currently using a water wash batch cleaning system, closed loop. I am looking for a better result when cleaning and thinking of introducing a chemistry. What is the best chemistry to use? Will using a chemistry to clean actually provide a bett
Electronics Forum | Thu Feb 18 18:25:33 EST 2010 | tony_d
Hello Bryan, My recommendation is MIRTEC by far. We checked out several machines and narrowed the selection down to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. We found that the MIRTE
Electronics Forum | Thu Mar 29 15:38:54 EST 2001 | genny
We have been looking into some sort of higher level inspection system as well. But we have been fairly well convinced that X-Ray is far better than AOI. X-Ray is not only good for BGA's, it is also good for any solder related problems. AOI can onl
Electronics Forum | Wed Mar 28 11:53:50 EST 2001 | Steve
Take the leap of faith my friend!! Buy the AOI and watch all of your problems disappear. Okay, so I exaggerated a bit. Let me tell you the real story. We purchased a CR Technology RTI6500 almost two years ago. We chose the CR Tech unit because it wa
Electronics Forum | Thu Mar 29 16:34:18 EST 2001 | larryk
Genny, Would you use the X-Ray in addition to AOI? Or would it be in place of? If so, would it pick out wrong value components? Polarity? I never thought of it as a replacement. Seems like you have investigated into this. Do you mind sharing your fin
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400