Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Thu Jul 06 19:41:31 EDT 2000 | Hermie
We recently installed a new Servo-Amp which controls the X-Y table on our CP6 machine. Eversince, we are experiencing a Cycle alarm X-reach on the machine. We tried to greased the table a little bit more but the only thing that seems to work is to sl
Electronics Forum | Tue Jul 13 14:47:35 EDT 2004 | cyber_wolf
I have a brand new X/Y/Theta table for an SPM(The one that uses magnetic supports) that I would like to trade for an older version table.(The one that has holes drilled and tapped in it.) the one I trade for has to be in good condition. No stripped h
Electronics Forum | Fri Apr 14 13:36:44 EDT 2006 | cyber_wolf
Dax, More than likely your moveable rail is slipping on the X-Y table. Make sure there is no oil where the breaks grab the table. Sometime the breaks wear out and need replaced. The contact surface on the break lever is only a couple of thou.. We hav
Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Wed May 03 09:19:28 EDT 2017 | azdback
One of the pieces that attaches the ballscrew on the y table to the movable rail broke. Has anybody successfully replaced the ballscrew on the 500 t table? It does look labor extensive, not having done that before, it appears to be something better l
Electronics Forum | Wed Jun 12 09:37:13 EDT 2019 | key
We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Thu Oct 08 16:42:05 EDT 2020 | babe7362000
Does anyone have Page 6 and 7 of the MPM SPM manual? I am currently having issues with low air pressure that pushes the table in. I get good air that pushes the table to the entrance, but I do not get good air pressure that pushes the table in. I
Electronics Forum | Wed Dec 13 18:54:59 EST 2023 | hhudson
Good Afternoon, I was wondering if anyone knew what a calibration table is for an ionograph? I have a customer asking for one and am unsure. My first though would be a table that correlates SIR values and converts them the ug/NaCl equivalence? Can s