Electronics Forum | Thu Jul 19 08:33:37 EDT 2007 | allgood
Ok I can get into the service program - under Motors there is only a single X motor listed. And what test can you do - seems that I can only display ranges and settings? No test as such?
Electronics Forum | Wed Jun 20 12:16:59 EDT 2012 | allgood
Hi John Yes I am still having the same problems years later! It keeps Fred in work supplying me with replacement tips too! Mydata came up with a supposed fix to alter a parameter called prepick which puts a pause in I think allowing the head to st
Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood
Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l
Electronics Forum | Wed Jul 18 06:47:38 EDT 2007 | cyber_wolf
I was asking if it was a TP9 2U...... If you have a UFP machine then you are in luck. It is most likely the small X-motor. You can test it in the service program. Does the X-axis bounce when you are trimming magazines and stepping through placement
Electronics Forum | Wed Jul 18 08:07:27 EDT 2007 | allgood
OK thanks - I wasnt aware that I HAD a small x motor! You mentioned being able to check in the service menu - would you care to point me in the right direction. What amazes me - or rather, worries me, is that repeated mentions to the Mydata service
Electronics Forum | Fri Jun 08 12:54:28 EDT 2012 | fredc
The original post was back in 2007. My most recent communication with Peter was last year and he was still having the problem 4 years later. Since it is temperature related, I am suspecting the card in question got partially cooked once and is now al
Electronics Forum | Wed Jun 27 12:19:34 EDT 2012 | allgood
We concur - we reduced problems by lowering the booster panel to the horizontal and putting two pedestal fans behind the machine blowing onto it - but I think once the ambient air has heated up the cooling effect is reduced of course - we have a smal
Electronics Forum | Wed Jun 27 13:38:56 EDT 2012 | upguy
Thanks for the information and insights. Our booster is probably getting too hot, even with AC. There is bouncing when we trim component locations. Every so often, while trimming component locations, the x-axis will start to slowly move away (by i
Electronics Forum | Tue Jul 17 10:47:54 EDT 2012 | upguy
As as per your information and photo, we attached two box fans under our booster and attached them to the white XGTS connector. The fans are blowing upward with airflow between the booster board and the back of the machine. We will carefully watch