Electronics Forum | Mon Jul 21 16:06:02 EDT 2003 | davef
We doubt that stain gages will provide the granularity or repeatability to provide meaningful data. Contact: Cemal Basaran, Dr Associate Professor SUNY Buffalo Work: 716-645-2114 X2429 Fax: 716-645-3773 E-Mail: cjb@eng.buffalo.edu 243 Ketler Hal
Electronics Forum | Mon Apr 26 17:05:36 EDT 2004 | babe
If you have deep pockets and wish to spend alot of money over the next few years, then yes, call Metcal. Whatever solder iron you plan to use, it is my suggestion that you take a look at the board that you are going to solder. How big are the pads? H
Electronics Forum | Thu Dec 28 15:40:13 EST 2006 | fredericksr
The fluxes involved with lead-free soldering tend to be more aggressive and the tip deterioration is a side effect of making the world a greener place. I am not certain if any of the tip manufacturers claim to have lead-free resistant tips. I would
Electronics Forum | Thu Dec 28 15:11:19 EST 2006 | laurieg
WE are experiencing a faster than usual deterioration of solder tips. We have been conducting a cost study of our current irons/tips and are trying to decide whether to upgrade the irons or not. Is anyone else experiencing this problem (could the c
Electronics Forum | Wed Jan 03 20:30:11 EST 2007 | mrduckmann2000
We too are having issues with our soldering iron tips. We purchased the new Weller WD series irons which we were told would work just fine with lead-free solder. The Weller unit has changed 3 times in the last year(latest unit is the WD2M series).
Electronics Forum | Tue Jan 02 08:11:21 EST 2007 | Rob
Try using a solder like S03X7C from Koki, which uses cobalt to prolong the tip life & also a wire wool type dry wipe instead of a wet sponge.
Electronics Forum | Wed Jan 03 21:14:45 EST 2007 | davef
After searching the fine SMTnet Archives, two threads on disappearing LF solder tips are: * http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=35436 * http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=41300 There probably are more t
Electronics Forum | Thu Feb 24 01:50:50 EST 2011 | kprincemoses
Hi mate... I want to use the allegro 16.2 pcb editor tool to design a layout for one schematic. i have generated the netlist(mnl file) for allegro using orcad capture. Can u please guide me that what is the step by step procedure to be foll
Electronics Forum | Mon May 06 14:55:55 EDT 2002 | jdill
Hello Do any of you out there with Philips/Assembleon machines have any tips or tricks to repairing there feeders. I call Assembleon and one guy tells me to clean the heads and the feeders with a small lint free brush and to not use any oil on the he
Electronics Forum | Tue Apr 15 14:19:19 EDT 2014 | horchak
This does not look difficult. It appears the rectangle of proper size and spacing would work for both, or even a square pad. Don't make it more difficult than it should be. But then I could be missing something?
