Electronics Forum | Thu Nov 07 09:52:27 EST 2002 | dougt
Not being a smart alic, just curious....... So if velcro is made out of that black esd safe material then it is safe to use around sensitive parts? Is there no static discharge or is it transferred to the tray and out the mat/wriststrap? They could
Electronics Forum | Thu Jun 03 03:30:23 EDT 2004 | johnjohn
Talk to Altus-Group they will advise you on all of your needs support, product transfer the lot these guys are really good they have all come from factories with years of equipment experience I have used them and they were excellent www.altusgroup.b
Electronics Forum | Fri Jul 02 03:51:14 EDT 2004 | HARAN
I was told by my boss that the new product will be transfered to my facility will have the Super BGA and Hyper BGA.Can I know what is the difference of these 2 components compared to normal BGA.Is there any difference in the assembly process and requ
Electronics Forum | Sat Feb 12 13:19:27 EST 2011 | tpappano
A simple trick I read either here or on another P&P forum is to use "Silly Putty". Place a small thin spot of Silly Putty on the top of the front conveyor rail, and put the machine in "manual" mode. Steer head #1 over the putty and lower it, leavin
Electronics Forum | Wed Dec 09 05:01:33 EST 2015 | luki
Hello, I am a new user of the machine CSM84VZ III and learn to program. After formatting a disc machine lost all settings(I did not know that the settings are on the disc), most of which I have already set. Now I have a problem such that when I try t
Electronics Forum | Tue Apr 10 04:16:20 EDT 2012 | grahamcooper22
you are seeing a typical issue that is caused when such small volumes of paste are printed....there are several reasons for it..the tiny amount of flux in the small deposit becomes exhausted much quicker then it does in a larger deposit ( the flux ma
Electronics Forum | Mon Jul 17 13:36:55 EDT 2006 | kjeffries
I appreciate your comments regarding the programmability of the Mirtec. What type of SMT machine do you use? How easy have you found it to transfer the SMT profiles to the Mirtec? How do you rate the Mirtec in handling top/bottom, multi-panel asse
Electronics Forum | Mon Jun 26 08:57:17 EDT 2017 | capse
If N2 is not an option, the cut wire feeder or drilled wire are your best bet for now. You need to optimize wire feed rate as well. The solder joint on the robot takes about the same time to form as in manual soldering. If you need to speed the solde
Electronics Forum | Fri May 22 12:42:43 EDT 2015 | deanm
Sr. Tech, you are right in that there is no verification of the profile. We are a Class 3 high mix OEM. We have visual inspection after SMT. We have not seen problems with wetting, grainy solder, cold solder, charred boards, etc. that would indicate
Electronics Forum | Wed Aug 23 17:43:42 EDT 2023 | calebcsmt
Support bars, so essentially the board is sitting ontop of beams that make a table. Fully supported with no soft spots
.gif)
