Electronics Forum | Tue Sep 29 11:37:52 EDT 2015 | robl
Hi Marlyn, We use durastone pallets over a wave - so areas machined out so the solder can get to the pins but not the SMT. You can also get fancy selective solder machines, but I'm guessing that as you're asking you haven't got one. Hope that help
Electronics Forum | Thu Nov 02 04:42:48 EDT 2023 | tinaheussaff
In general, it is safer to use a single alloy with a known composition and performance characteristics. If you need to change the alloy used in your selective soldering machine bath, it is advisable to consult with the manufacturer or a soldering exp
Electronics Forum | Tue Oct 18 10:36:46 EDT 2022 | winston_one
Dear proffessionals! Question is about this alloys - Sn99Cu07 and Sn100 (Sn100C,Sn100Ni+ etc.). Is it O'k to mix them? In my case to use Sn99Cu07 as addition to selective soldering machine bath with Sn100C? Main components are the same, but minor add
Electronics Forum | Fri Mar 27 12:46:23 EDT 2020 | unisoft
Unisoft has been import gerber only for years to setup assembly, aoi machines, etc. *** Help for Importing GERBER only files for used in programming Assembly, AOI, Test, Selective Soldering machines (X/Y Center, Rot, Part#). Also allows you to cre
Electronics Forum | Tue Dec 10 14:10:38 EST 2002 | Randy Villeneuve
Steve, I wave solder most if not all our boards with selective wave pallets. I did not catch if the solder balls were on top of the board or on the bottom but that will make a difference on what to do to get rid of them. Pallets are good and bad. On
Electronics Forum | Wed Oct 26 14:20:41 EDT 2005 | TPM
Brian, We have the Mirtec Table Top. It is very good at detecting the component and orientation. It is however only as good as we program it to be. We have seen some limitations in respect to solder connections. I have not found it to be 100% re
Electronics Forum | Mon Jan 15 09:19:29 EST 2007 | tk380514
We use Alpha EF-2202 low-VOC No-Clean flux Selective wave soldering cassettes Bottom pre-heating wave soldering machine We have one component that will not solder properly: http://www.epcos.com/web/generator/Web/Sections/ProductCatalog/Capacitors/Ul
Electronics Forum | Wed May 13 13:22:39 EDT 2015 | cohlmann
Hello Everyone. We are setting up our first SMT line and are looking for recommendations on printers and reflow ovens. Currently most of our manufacturing is outsourced and we want the ability to manufacture all of our products in-house. One impor
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sat Mar 11 08:53:44 EST 2017 | tch
My company is looking for a vacuum that can handle being used to clean up solder splashes on the bottom of our wave solder machines and around the solder pot area in our ERSA Selective Solder Machines. In the past we would use a Shopvac but these don