Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Mon Feb 26 12:26:43 EST 2001 | CAM
I'm working a problem and looking for your input. Here the deal: Two sided mix technology board. Test is using unmasked via points on bottom for test points. Our fab drawing states tent via points on top side. First set of board came in with no tenti
Electronics Forum | Tue Sep 17 08:26:28 EDT 2002 | davef
Try: "Increasing Density By Placing Vias In Lands"; Blankenhorn, JC; 'Printed Circuit Design'; 11/98
Electronics Forum | Thu Jan 12 14:17:07 EST 2012 | blnorman
How are the vias failing? Barrel crack?
Electronics Forum | Tue Jan 17 12:06:12 EST 2012 | cobham1
The via's are cracking which then is causing all kinds of problems.
Electronics Forum | Sat Mar 27 08:15:02 EST 2004 | davef
Via in pad is a designer's dream and an assembler's nightmare. Search the fine SMTnet Archives for previous discussions to get started. VIP, via-in-pad, or whatever tend to promote voiding within the via and certainly partially starved solder conne
Electronics Forum | Thu Mar 15 13:27:45 EDT 2007 | Pete
We had a customer do a similar thing. We notified our customer and educated them on what was happening. We were instructed to try one and report on the results, as the vias were supposed to be filled (and weren't). We pasted and reflowed and as su
Electronics Forum | Sat Oct 12 05:40:05 EDT 2002 | Kenture
Hello All, I am having issued with insufficient solder due to via in pad. It is a 10 mils via and PCB is 70 mil thick. Six mils stencils was used since there are some 20 mils (No clean process). Any recommendation? Thank you.
Electronics Forum | Wed Feb 27 19:55:13 EST 2002 | nifhail
Hi, I need help to understand further on the via in pad for 0402 requirement. If I were to do the DFM over the brd design which consist of 0402 with via on pad, what is the criteria that I should look for ? I learned that the via in pad does not wor
Electronics Forum | Tue Oct 15 15:16:34 EDT 2002 | Abelardo Rodriguez Santana
We run into that issue all the time. If a corrective action must be done right away. Place Kapton tape on the bottom side of the board to cap off the via. If you have room to place tape if not use pink lady or something to plug the via. And weathe