Electronics Forum | Mon Jan 13 17:50:54 EST 2003 | jonfox
I was looking for some good documentation that could nail down some pros/cons of voids, but haven't found any. The biggest issue is if you are going to temp cycle the chips/PCB after assembly. Depending on the cycle, the situation of the test, it c
Electronics Forum | Thu Jan 16 04:02:18 EST 2003 | johnw
The IPC 610 actally conflict's with 7095 which give's a better indication of what's acceptable. I believe that IPC are reviewing both. Motorola did a bunch of work before basically showing that void's aren't that bad up to a certain size, I think pro
Electronics Forum | Mon Apr 27 19:31:12 EDT 2009 | stevek
Remember that the 25% is a reduction in cross sectional area. A void in the middle of the ball that reduces the cross sectional area by 25% is about half the diameter of the ball. If it is closer to either termination, the corresponding size would
Electronics Forum | Wed Jan 15 23:32:36 EST 2003 | tinson
How about section 12.2.12 of IPC-A-610C? It doesn't include detailed description of root cause/effect but acceptance criteria.
Electronics Forum | Mon Jan 17 18:36:26 EST 2000 | William
Voids can be acceptable @ 24% per 5 balls area, and 8% per single ball area. In fact, Proceeding Book 1996; Vol. I, Page #126 conclusions saids: that solder joint voiding at the maximun levels pbserved in this study (were voided area was up to 24 per
Electronics Forum | Mon Jan 17 21:01:21 EST 2000 | Dave F
Dennis: On your BGAs: * Never seen voids any place other than the top ... lower density stuff rises. * Our spec on voids says: 1 Voids 1a Voids in soldered balls shall be less than 20% of the diameter of the solder ball. 1b No void shall sho
Electronics Forum | Tue Feb 19 22:50:00 EST 2008 | amarpreet41
Do you of reducing hole size of DIMM connector will improve solder voids??
Electronics Forum | Wed Feb 09 06:35:18 EST 2000 | Mark Williams
Hi We use 2 criteria... maximum void size is 10% of the solderable surface and a maximum area of voids of 10% of the maximum cross-sectional area of the ball. Any views Mark
Electronics Forum | Mon Mar 12 08:27:00 EDT 2007 | rgduval
Have you checked the parts for contamination? Are the voids out of spec? IPC allows some voiding, especially with lead free solder. Component contamination can cause this to repeat, as well. Try pre-tinning the component in question, and see if s
Electronics Forum | Sun Aug 19 15:34:20 EDT 2007 | davef
What are you trying to do: * Improve hole fill? * Reduce PTH voiding? Hole fill: Search the fine SMTnet Archives for stuff like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=36063 PTH voiding: Ideally, there are no voids. We're unawar
