Electronics Forum | Thu Jul 15 14:55:24 EDT 1999 | JohnW
| I'm designing a board where the parts will only fit if I do one of the following: | | 1. Put BGAs on both sides | | 2. Put BGAs on top, smt TSOPs directly underneath and using blind vias to keep the real estate on the bottom side below the BGA pa
Electronics Forum | Fri Jul 13 08:54:18 EDT 2007 | rgduval
Has your board house reviewed the PCB layer stack? Make sure that the layers are balanced in copper weight, etc? Have you tried pre-baking the boards? We just had an issue with some boards warping that have never warped before for us. It happened
Electronics Forum | Fri Jul 16 17:39:33 EDT 2010 | deanm
It is a PCB design issue where the copper patterns are not balanced among the layers. Baking the boards in order to correct the warpage will not improve it. We've had a problem with one bare board in particular warping the same way from two differen
Electronics Forum | Wed Jun 03 11:17:17 EDT 1998 | Brian Stumm
If your board is single sided you should convey it on a mesh belt conveyor. Unfortunately most assemblies these days are double sided which makes it difficult to convey on the mesh belt. Plus with the increasing population on SM boards the weight is
Electronics Forum | Wed Jun 03 14:37:53 EDT 1998 | Anthony
I really appreciate everybody taking the time to help me out with this problem. I'm going to run your input by the design engineer, after that I may be taking you up on that offer to contact you Earl. Again; thank you! Anthony | If your board is si
Electronics Forum | Tue Apr 23 01:39:29 EDT 2002 | ianchan
Hi, 1) Was reading the links provided by Dave F, under the thread "waste" which was about the ESD grounding of drums. 2) thanks to Dave F, now have "back-bone" refer sources to explain ESD terms to those who ask and seek to better understand this n
Electronics Forum | Thu Jun 25 14:41:07 EDT 1998 | Earl Moon
| Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection Handb
Electronics Forum | Thu Aug 10 13:12:10 EDT 2000 | Bob Willis
You may care to review the following from my Circuits Assembly page on line. "HOW FLAT IS FLAT AND DO WE NEED FLAT CIRCUIT BOARD, YES WE DO ? As production problems go there is one that keeps reoccurring time and time again. The blame is usually di
Electronics Forum | Fri Jun 26 11:27:12 EDT 1998 | Earl Moon
| | Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection Han
Electronics Forum | Fri Jun 26 15:37:50 EDT 1998 | Justin Medernach
| | | Alright gentlemen and ladies of the forum, I again seek knowlage on what is probably a well known fact. I have spent a good part of the morning with various IPC standards and weighty tomes such as the Electronic Packaging and Interconnection H
