Electronics Forum | Mon Nov 07 19:33:10 EST 2011 | swag
We have four pick and place machines all exibiting a residue that seems to build up over time on wiring and electrical components. This residue appears as a white haze on wiring, caps and fuses (these are the components where it is most obvious). Y
Electronics Forum | Wed Aug 17 22:41:37 EDT 2005 | davef
Peter are you having fun with solder masks erwat? We saw this years ago with LPI solder masks. It shows occasionally with other masks. We agree with Russ. If nothing [eg, alcohol, flux thinner, acetonitrile, or water] dissolves the haze, then it
Electronics Forum | Sat Nov 08 09:42:22 EST 2003 | ethercom
Hi: I have seen this problem before. It is caused by improper curing of solder mask by the fab manufacturer. When you run the board thru' wave solder, and then wash the board, you see the problem of white residue. However, when you apply heat, you c
Electronics Forum | Thu Feb 16 13:21:24 EST 2006 | Bill C
Hi Russ, Thanks for the reply. No this is 856, I sprayed some on boards just to try it out and noticed it dries very quickly also but if its soldered right away as would be the case in the machine, it's fine. I believe I tried some 857 and found th