Electronics Forum | Fri Jan 08 08:29:48 EST 2016 | ahanna
Water can be the issue. After Christmas break we came back to find a fair amount of water build up in our airlines for the building. I will check out the regulator as well as the solenoid. Thank you. I appreciate it.
Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t
Electronics Forum | Wed Aug 19 01:55:18 EDT 2020 | unsung
Hi Jon this marlon Reach out to me to my email marlonquiroz84@gmail.com So I can send you some pics of what could be your error issues. Thanks Marlon
Electronics Forum | Tue Feb 09 08:48:29 EST 2010 | davemacnemo
Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's worki
Electronics Forum | Tue Feb 09 12:47:56 EST 2010 | swag
Refer to the thread started by Deni on 2/4/10. Your problem is similar.
Electronics Forum | Thu Jan 27 16:06:19 EST 2000 | Dan Green
IPC apologizes for www.apex2000.org being temporarily unavailable. IPC recently switched Internet Service Providers, which led to this problem. Corrective action is underway. As Roland Gorouard noted, you can still reach the APEX Web site through
Electronics Forum | Mon Mar 15 18:03:21 EDT 2010 | smt_guy
hi, check the home sensors if they are working specially on the right side rail of the camera where you had the failure.
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Fri Aug 11 13:38:52 EDT 2023 | lauri
We have a Contact 3AV pick and place and we can't get the table to home. Any solutions?