Electronics Forum | Fri Sep 14 13:00:28 EDT 2012 | mark25y2001
Try to check encoder if properly locked, also check encoder connector if properley inserted, if all good, it's possible that the conveyor controller or encoder problem... to check controller related just try to set in zero value, then if conveyor are
Electronics Forum | Sat Nov 23 08:05:20 EST 2013 | emeto
Hi, I would check the thing in the following order. 1. Check paste - SPI is the best way. If you don't get the right deposit there is no wonder you have issues. 2. Check reflow profile - tweak it to the point of perfection for the board you have. 3
Electronics Forum | Sat Jan 18 03:18:04 EST 2014 | smtspareparts
Should be too high temperature on somewehere on machine, 1 Check cooling oil tank, If the cooling oil need replaced? Check the radiator of cooling tank, withdraw the filtering net and clean it,and clean the dust off the radiator of cooling tank wi
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
Electronics Forum | Wed Dec 31 09:10:48 EST 2014 | rgduval
If you suspect a short, check the resistance on a new board that hasn't been powered up. The data sheet should give you the junction resistances that you're looking for. Double check against a component not assembled on the board. If you measure a
Electronics Forum | Fri Aug 14 10:02:23 EDT 2015 | swiese242
Yes your CP8 should place these flawlessly. I would calibrate the machine and check your nozzles. We have some CP7's and they rock. We use a .4 nozzle for the 0201's with no problem. Always check your program, feeder, nozzles, and nozzle check before
Electronics Forum | Thu Jan 21 15:36:37 EST 2016 | brantco
I have the Error message E00900 i have checked the troubleshoot and it says to check SP1 XP6 and Y1 i have checked SP1 its ok, Relay XP6 seems ok Y1 i dont know where it is located here is the error "Air Pressure Fault" any help would be greatly
Electronics Forum | Thu Aug 17 06:02:37 EDT 2017 | smeissner
Is anyone using an AOI machine for through-hole > checking? We have a need to check post-build on > some PCBs', but there doesn't seem to be any > obvious AOI solution. > > Is there such a beast > available? Check Goepel. They developed a Spec
Electronics Forum | Wed Jan 29 07:10:19 EST 2020 | dontfeedphils
I'd recommend checking with the manufacturer of your SMT equipment and checking into the feeder verification solutions they have. Combine that with a buddy check and true first articles before the line can continue to run the balance of the job an
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo