Electronics Forum | Tue Sep 22 10:52:31 EDT 1998 | Wayne Bracy
| We have problems with voids when we solder lids to | ceramic flatpackages. | The sealring of the package is gold(100 micro inches or 2.5 micro meters)with a underlayer of Nickel | The solder is attached to the lid (preform) and the solder material
Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Fri Jul 24 13:04:55 EDT 1998 | Dave F
| Hey youse guyz... | We're finally getting our first real job at the start-up I'm working at. It's actually a pretty unique little board too. Simple as all get out, but unique. You're not gonna believe what this goes into...guess? (I bet ya' you'll
Electronics Forum | Thu Jun 25 14:45:55 EDT 1998 | Chrys
| I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will sold
Electronics Forum | Wed Jun 03 21:25:33 EDT 1998 | John Allan
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Thu Jun 04 08:32:21 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Mon Jan 19 20:01:11 EST 1998 | Steve Gregory
| We use no clean paste and sometimes experience | flux splattering which gives spot on gold fingers. | Need help in analize the cause. thx. Dominic, That is STILL a problem huh? It's a tough one to solve sometimes...especially when you have as
Electronics Forum | Tue Aug 21 21:39:19 EDT 2001 | davef
1) why is No-clean (NC) the preferred process, for BGA mounting by SMT? Probably the same reason NC is the preferred process for mounting non-area array SMT components. 2) why is water-soluble (WS) not a hot choice? There�s not reason not to use
Electronics Forum | Mon Mar 11 13:11:00 EST 2002 | steve_arneson
I have read all of the previous threads and have found it very hard to believe what I am hearing. The idea that AOI is not needed on your production line is like running a marathon without training before hand. You can only expect to get out of an
Electronics Forum | Thu Mar 21 21:21:37 EST 2002 | davef
In the beginning, there was TO-5. And it was good. Flushed with success, they created TO-220. It too was good. Then came SMT. It was better than some things, but then again ... In these early days, there was a haze on the horizon that blocked t