Electronics Forum | Wed Nov 06 13:01:54 EST 2002 | cvrgirl
Hi, Has anyone experience BGA caps/plugs popped off after assembly on a double sided board? Only the caps on the primary side popped off and exposing copper. thanks! Michelle
Electronics Forum | Thu Nov 14 09:02:46 EST 2002 | MA/NY DDave
Hi Making contact has been one reported problem, so some testers put in higher force probes that then might cause problems. If fixturing is done correctly, the OSP is done correctly, and test follows close in time after soldering little problems s
Electronics Forum | Mon Dec 16 10:31:21 EST 2002 | davef
Grant, On those 'dry pads', where does the solder paste end-up after soldering? On: * Pads * Component leads * Someplace else [Where?]
Electronics Forum | Thu Jan 16 11:56:01 EST 2003 | dgjjr
I babysit a couple of Amistars/Tenryus here at our facility. They're good kids if you stay after them. What models do have?
Electronics Forum | Mon Mar 17 15:51:35 EST 2003 | MA/NY DDave
Hi A GREAT come back!! After a Wait to see "Show and Tell" To change the topic you launched a little. Who has or has had, this ENIG problem??? A simple yes or no with some detail. YiEng, MA/NY DDave
Electronics Forum | Fri Feb 21 12:52:05 EST 2003 | russ
Are you 100% positive that the parts are on before wave? I have found that asking an operator "were they there before?" does not always provide for an accurate answer. how is your handling before and after the wave process? Russ
Electronics Forum | Sun Feb 23 15:28:35 EST 2003 | davef
"Blank" means "bare board". Gray beards used this expression a lot. It has stuck in many companies, even after the old timers went to work on the BIG wave solder machine in the sky.
Electronics Forum | Thu Apr 10 10:43:23 EDT 2003 | chrissieneale
Thanks for all the posts, i'm off on holiday for the next two weeks, but i know this problem will be around after i get back so hopefully i will be able to update you as to whether the board passes test or not!
Electronics Forum | Thu Apr 24 13:07:48 EDT 2003 | Mr. B
Yes it is Di water and is tested after washing. The customers boards pass inspection testing before the wash but the customer likes to see them CLEAN.
Electronics Forum | Mon May 19 19:32:50 EDT 2003 | Dave
Hello. We have a low profile LCC on a board. The clearance is ~ 2mils after reflow. Cleaning away residual flux with an ultrasonic 50C water cleaner caused some LCC and 0201 components to loosen. Should we stay away from the ultrasonic cleaner?
