Electronics Forum: iron (Page 17 of 71)

Solder Joints

Electronics Forum | Wed Jan 16 12:30:38 EST 2008 | davef

As Rob says, blowholes and pinholes are process indicators. Reworking them most likely makes the solder connection less reliable, because it is very difficult to heat the solder connection properly. Shrewd rework-types "paint" solder over these open

Wire soldering

Electronics Forum | Mon Mar 03 07:39:24 EST 2008 | realchunks

I would choose wave over hand solder. Top side wetting due to thermal mass will be your biggest obstacle. Of course I don't know the size of your soldering irons or how weak your wave may be.....

Good Lead-Free soldering Iron???

Electronics Forum | Thu May 08 15:53:28 EDT 2008 | radab

I love my Pace ST-30. Not too expensive and works a charm. Tips are also reasonable at $6-$15.

Good Lead-Free soldering Iron???

Electronics Forum | Fri May 09 13:25:31 EDT 2008 | ldbepurchase

we sell the Hakko type 900M-T tips that fit for 936 soldering stations for $5 only. Shipping included. Reply if interested.

Good Lead-Free soldering Iron???

Electronics Forum | Tue May 13 02:28:43 EDT 2008 | lococost

I'm not affiliated with JBC in any way, but I do agree you should take a look at them.

Ultra low cost pick & place?

Electronics Forum | Tue May 27 20:03:18 EDT 2008 | mobytahoe

Insane, inane and a waste of everyone's time. Buy a soldering iron at Target and have it. A cheap machine cannot do what you plan. If it could, China would already be selling them.' Get a clue.

Removal of silk screen on PCB??

Electronics Forum | Wed Jul 23 13:50:18 EDT 2008 | realchunks

On or off a pad? If on pad just take a soldering iron and some solder to it. Wick off to relevel. If off a pad - why remove? (just curious)

SN100 Solder Bar

Electronics Forum | Wed Dec 10 03:15:43 EST 2008 | meritajs

We have had expierience to convert our wave solder machine EPK1(1995g)with cast iron solder pot for lead free SN100.It runs about year and half now without problem.

SMT pressure pipes sealing

Electronics Forum | Tue Mar 31 19:50:22 EDT 2009 | davef

8 bar is over 100 psi. What are you using that much pressure? So, your piping is made of what material? * Black iron * Copper Can you run soft pressure piping to by-pass the section that requires sealing?

SMT pressure pipes sealing

Electronics Forum | Thu Apr 02 04:36:40 EDT 2009 | d0min0

Piping is made of *black iron, we had a visit from external company that promised us to find the right material for that :) we will see


iron searches for Companies, Equipment, Machines, Suppliers & Information

Dual Lane Reflow Oven

Best Reflow Oven
Precision Auger Dispense Pump

Reflow Oven
SMT feeders

High Throughput Reflow Oven
ACI Technologies, Inc. - Analytical Services - Failure Analysis - Advanced Imaging - Cleanliness Testing - Counterfeit Component Screening - Reliability Testing - Bare Board Qualification

回流焊炉