Electronics Forum | Mon Oct 12 03:12:42 EDT 2020 | erici
TP11 is always showing the error that E-stop is not released. This happens when we start up the machine. It is basically hit and miss, sometimes will work but most of the time this error will pop up. Any suggestions on how to correct this. Is ther
Electronics Forum | Thu Sep 04 16:36:29 EDT 2014 | chemers
Thanks for the response, Rob. I tried the MOT cards and the problem did not move. I swapped the MOTY with the MOTX, but the MOTX had a small board attached to it that I moved to the MOTY that I tried. Do you know if there is a way to test that small
Electronics Forum | Mon Aug 06 18:58:12 EDT 2007 | edruppert
This message indicates that the Peak to Peak voltage for the x axis motor encoder is too low. Possible cable/encoder or MOT1 board problem. Machine will either exhibit this during intialization or while running. Diagnostics in service routine may he
Electronics Forum | Tue Sep 08 09:37:55 EDT 2009 | cyber_wolf
We are seeing intermittent X-transducer errors. I notice that the X-wagon has more resistance over the Y-wagon area when I manually push it back and fourth. I am thinking the belt might need replaced. Has anyone else seen this before.
Electronics Forum | Tue May 07 13:41:36 EDT 2013 | cyber_wolf
MOVFI is a theta error there are about 10 things that can cause it. Start with making sure you do not have an acceleration set to lowest while the others are at high or highest in the package data. Next look at ribbon cables...
Electronics Forum | Thu Oct 18 16:09:34 EDT 2018 | emeto
Interesting. What changes in 1 hour? Is there any connection between the error and feeder/magazine change, load reload? Is there any other factor observed in the hour of work that is abnormal?
Electronics Forum | Wed Oct 24 09:31:26 EDT 2018 | tech1
It could be the indicators inside the Z head, have you tried cleaning them? Can you post an image of the error that appears on the monitor?
Electronics Forum | Wed Oct 24 10:02:17 EDT 2018 | tech1
That error points to a hardware issue. When it fails does it ask you to insert a tool manually?
Electronics Forum | Thu Oct 17 13:59:58 EDT 2019 | mendezt6
Trying to install A12 tool, fails to fetch tool. Error: Preliminary fetch failed, try to unlock tool manually.
Electronics Forum | Wed Feb 12 14:39:23 EST 2020 | SMTA-Alex
Do you have a photo of the actual error?