Electronics Forum | Fri Nov 19 21:24:25 EST 2010 | rodrigo
I saw a lot of people read this post but no one answer me so I thought someone may be interested to know how this thing works. My problem was in the "F4G_LINE.CFG" file. The "RTM" heading had a "NO" when it should have been "YES". This will make wha
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Mon Feb 07 18:12:56 EST 2011 | eadthem
I do not know what software version you have, but on older versions it is best to have a mounting inspector set to be the primary and then mask out all labels and solder so it just locates the part. Then add another mounting inspector for looking at
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Wed Nov 16 05:12:36 EST 2011 | bobpan
A couple of things i would try: 1. Does function 30 give you a nozzle height that is repeatable. The number should be around 200.....+/- 20 or so. 2. I would change the z-rod because the spring could be worn out and when the vacuum turns on....it ca
Electronics Forum | Fri Nov 18 16:26:17 EST 2011 | olddog
Hi again Bob, I checked the theta motor coupling and the set screws are definately tight. I noticed that the theta motor drives an snti-backlash gear (nice design) so there is no play there. It appears that the gear drives a slotted shaft which is d
Electronics Forum | Wed Dec 14 22:13:00 EST 2011 | deanm
I would first check the moisture barrier bag that the parts come in. There is a label showing the MSL level on the bag and sometimes included with the information on the reel. Transfer this info to your MRP system. If your receiving department throws
Electronics Forum | Thu Dec 15 10:44:53 EST 2011 | davef
Hi Joe This last sentence was not included in previous versions of J-STD-001. So, the first sentence required that all components, wires and boards had to be tested for solderability prior to use. We're talking 100% testing and inspection. That's bu
Electronics Forum | Mon Mar 05 22:33:31 EST 2012 | acsscott
We are trying to optimize it to pick up 8 components, then move over the camera, then to the PCB and place them. In the Mount data, we load heads 2, 4, 6, & 8 with a 3216 Resistor, then them next 4 components are LED's, and are loaded on heads 1, 3,
Electronics Forum | Tue Feb 21 16:38:18 EST 2012 | comatose
We finally can't avoid adding wave solder to our process anymore. For lead-free, medium sized wave I'm leaning towards mid 2000s senju units as the best fit. I've never run their equipment. Opinions? As a point of reference for our general capabilit