Electronics Forum | Fri Nov 29 19:37:09 EST 2019 | luis
Please, need help about CSM Comet PA1307/XX. After a correct initialization, when push ready button, indicated L015 error. "M POWER DOWN". Appreciate if anybody has information about it. Thanks.
Electronics Forum | Mon Dec 23 11:41:09 EST 2019 | michealsean
After saving the changes I've made to running-config on my Cisco L2 Switch, I restart the Switch, but all settings are resetting. I have the IOS image I downloaded here. Should I upgrade the Switch's IOS software?
Electronics Forum | Wed Jan 01 22:19:33 EST 2020 | sssamw
Solder ball attached on solder joint without violation minimum electrical clearance is acceptable. If your process parameter including stencil not changed, suggest you check if solder pasted being pushed out after IC placement, also check if solder j
Electronics Forum | Tue Jan 07 07:55:24 EST 2020 | dekhead
If it happened after holiday shutdown; good chance you have onboard battery going bad (battery dropped too low during extended shutdown). Replace batteries to alleviate future occurrence.
Electronics Forum | Wed Jan 22 07:05:11 EST 2020 | dontfeedphils
Just make sure they're in different parts of the bag before vacuum sealing. After the bag is sealed, neither will be going anywhere (unless your sealer isn't up to snuff and the bag leaks).
Electronics Forum | Tue Feb 11 01:34:14 EST 2020 | jineshjpr
Dear Team, Can any body suggest that which is the best cleaning agent to remove the AIM M8 Flux residues from the PCBA After SMD Assembly by using Air agitation Method or with Ultrasonic Method.???
Electronics Forum | Wed Feb 12 19:06:28 EST 2020 | SMTA-Alex
I see that the connector has plastic alignment pins. Is there any reason you can squirt a drop hi-temp "Crazy" glue into each hole, after the bottom side assembly and before printing the top side?
Electronics Forum | Mon Mar 02 16:58:41 EST 2020 | rlising
Has anyone on the forum own a EASTONTECH EW-02A wire stripper and cutting machine? I get a message after a cut. Output amounts vlue. Please recount.
Electronics Forum | Fri Jun 12 18:21:52 EDT 2020 | proceng1
I've had components move in the pocket and cause mis-picks. Generally, the part moves, but settles in the pocket after a moment. So I slowed down the pick up speed. It gave the part in the feeder a chance to settle before picking.
Electronics Forum | Wed Mar 11 17:52:24 EDT 2020 | slthomas
Anyone here actually join the chat? I took a look at the feed after the fact. Mostly stuff that we've talked about here a lot over the years, in a little more concise package.